MCQGeeks
CBSE
JEE
NTSE
NEET
English
UK Quiz
Quiz
Driving Test
Practice
Games
Quiz
Arduino
Arduino Multiple Choice
Quiz 1
Solution
Q.1.
What is the use of the Adafruit FONA 3G+GPS Breakout?
a) To measure luminosity of something
b) To provide 3G Connectivity
c) To measure temperature
d) To measure Wi-Fi strength
Q.2.
Which module enables GPS capabilities to the Adafruit FONA 3G+GPS Breakout?
a) Qualcomm 8015
b) Qualcomm 20111
c) Qualcomm 234
d) Qualcomm 8013
Q.3.
What kind of commands does the Adafruit FONA 3G+GPS Breakout accept?
a) Analog Commands
b) BT Commands
c) AT Commands
d) TDM Commands
Q.4.
What will happen if we supply a voltage ofto the Vcc of the Adafruit FONA 3G+GPS Breakout?
a) Damage is caused
b) Module will shut down
c) Module will not respond for the time the voltage is applied
d) Module will function normally
Q.5.
Which port on any Arduino board should be connected to the Key Port on the Adafruit FONA 3G+GPS Breakout?
a) Any Digital Pin
b) Vcc
c) Gnd
d) Any Analog Pin
Q.6.
What is the full form of the RI pin on the Adafruit FONA 3G+GPS Breakout?
a) Ring Indicator
b) Right Indicator
c) Right Impersonation
d) Rig Indicator
Q.7.
How many LED indicators are present on the Adafruit FONA 3G+GPS Breakout?
a) 2
b) 1
c) 10
d) 4
Q.8.
What signal should be sent to the RESET pin of the Adafruit FONA 3G+GPS Breakout in order to perform a Hard Reset of the module?
a) 100ms LOW Signal
b) Continuous HIGH Signal
c) 100ms HIGH Signal
d) Continuous LOW Signal
Q.9.
Do the SPK + and – pins on the Adafruit FONA 3G+GPS Breakout have DC blocking capacitors ?
a) Yes
b) No
Q.10.
What is the use of the RTSin pin on the Adafruit FONA 3G+GPS Breakout?
a) Right Turn Pin
b) Hardware Control Pin
c) Software Control Pin
d) Residue Transmitter Pin
Support mcqgeeks.com by disabling your adblocker.
×
Please disable the adBlock and continue.
Thank you.
Reload page