Q.1.

Air/gas ratio for complete combustion will be the highest for

Q.2.

Combustion of pulverised fuel

Q.3.

Steam is intermittently admitted into the fuel bed during the production of producer gas to

Q.4.

Wood charcoal is obtained by the destructive distillation of wood. It is used in the production of activated carbon, which is not used for the

Q.5.

'Wind loss' resulting from unscientific storage of coal may be the order of about __________ percent.

Q.6.

Preheating of coal charge for the coke ovens reduces the

Q.7.

Net calorific value is the gross calorific value less the __________ heat of water in the product of combustion when cooled to 15°C.

Q.8.

The catalyst used in shift converter is

Q.9.

Which of the following would require least amount of secondary air for combustion ?

Q.10.

The maximum adiabatic flame temperature in air as compared to that in pure oxygen is

Q.11.

Which of the following is unsuitable fuel for producer gas manufacture ?

Q.12.

Calorific value of coke oven gas is around __________ Kcal/Nm3.

Q.13.

Naphthalene is used for making

Q.14.

A good coking coal should have high __________ content.

Q.15.

In flue gas analysis by Orsat's apparatus, oxygen is absorbed by

Q.16.

Artificial draught produced by a fan can be controlled by the

Q.17.

Water gas constitutes mainly of

Q.18.

Moisture loss is determined by the

Q.19.

Beehive coke oven

Q.20.

Turndown ratio of a gas burner is equal to the

Q.21.

Presence of force moisture in coal is most disadvantageous during its

Q.22.

Gasification of the solid fuel converts its organic part into combustible by interaction with air/oxygen and steam so as to obtain a secondary gaseous fuel of high calorific value having no ash. Gasification reactions are normally carried out at about __________ °C.

Q.23.

Low temperature oxidation of coal during storage does not decrease its

Q.24.

In general, the limit of inflammability/explosion limit of fuel gases is widened by the

Q.25.

Which of the following is unsuitable fuel for producer gas manufacture ?

Q.26.

Washing of coal is done to reduce the

Q.27.

Volatile matter content in coking coal may be about __________ percent.

Q.28.

The main function of primary air in pulverised coal fired burner is to

Q.29.

The optimum percentage of excess air for combustion depends upon the __________ of the fuel.

Q.30.

'Fat coals' are those coals which have very high

Q.31.

Yield of charcoal in high temperature carbonisation of wood is about __________ percent.

Q.32.

A good metallurgical coke

Q.33.

Highly caking coals

Q.34.

The advantage of firing pulverised coal in the furnace lies in the fact, that it

Q.35.

A coal having higher volatile matter content, has lower

Q.36.

Pick out the wrong statement.

Q.37.

Coals used for the generation of producer gas should have

Q.38.

Natural draft created by the chimney depends upon

Q.39.

Oxygen required for theoretically complete combustion of 1 Nm3 methane is __________ Nm3.

Q.40.

Coke made in narrower by-product coke ovens (as compared to wider ovens) is

Q.41.

Purity of coke means that, it is high in carbon and low in

Q.42.

Tar is a better fuel than furnace oil, because of its

Q.43.

With increase in the oxygen content of the coal, its __________ decreases.

Q.44.

Caking coal is desirable for

Q.45.

Volumetric ratio of N2 to O2 in dry atmospheric air is

Q.46.

__________ is used as jet engine fuel.

Q.47.

Fuel for a nuclear reactor (thermal) is

Q.48.

Highly reactive coke have lower

Q.49.

A coal with high ash content

Q.50.

The main advantage of forced draft over natural draft is that