Q.1.

Copper has very low

Q.2.

High resistance electrical heating elements/wire are not made of

Q.3.

Cast irons are generally specified by their

Q.4.

Presence of 0.3 to 0.arsenic in copper increases its

Q.5.

The specific gravity of coal depends mainly on its __________ content.

Q.6.

Which of the following has no effect on the carbide forming tendency in steels ?

Q.7.

Softening of hardned steel is done by its

Q.8.

The crystal structure of most of the common metals is

Q.9.

A metallic alloy in general as compared to their pure metal components is

Q.10.

In the Contact process of sulphuric acid manufacture,acid cooler is made of

Q.11.

In hot wire aneomometer used for gas flow measurement, the wire is normally made of

Q.12.

Babbit metal is not a

Q.13.

Stainless steel is not corroded by

Q.14.

Low carbon steels are those in which carbon percentage is around

Q.15.

Hardest material so far found is

Q.16.

Which one is remelted and poured into moulds to get cast iron ?

Q.17.

The heat treatment process applied to cold formed steel parts is

Q.18.

Approximate value of the modulus of elasticity for steel is about __________ x l06kg/cm2.

Q.19.

Maximum permissible sulphur content in steel is __________ percent.

Q.20.

Telfon (PTFE) is corroded by

Q.21.

Pick out the wrong statement.

Q.22.

Platinum and silver are corroded by

Q.23.

The heat treatment process to which castings and the steel balls produced by cold heading are subjected is

Q.24.

Which of the following alloys does not contain nickel ?

Q.25.

__________ is added in stainless steel to prevent inter crystal corrosion.

Q.26.

White metal is an alloy of

Q.27.

Most suitable material of construction for the storage of concentrated nitric acid is

Q.28.

Wood metal is not used for making

Q.29.

The largest consumption of zinc for alloys is in the making of

Q.30.

Which of the following is the lightest of engineering metals ?

Q.31.

Nickel is a __________ material.

Q.32.

The carbonating tower used in Solvay process of soda ash manufacture is made of

Q.33.

Plate and frame filter press is usually made of

Q.34.

Evaporators used in caustic soda recovery and production plant are made of

Q.35.

Austenitic manganese steel used for making jaws of crushing machines contains about __________ percent manganese.

Q.36.

Constituents of stellite are

Q.37.

With increase in carbide/graphite ratio in cast iron, its

Q.38.

Sulphur melting pit in the sulphuric acid plant is made of

Q.39.

Which of the following has the highest compressive strength ?

Q.40.

German silver in an alloy of

Q.41.

Dielectric strength of a material is

Q.42.

White cast iron is not

Q.43.

18/8 steel is a/an __________ stainless steel.

Q.44.

Residual magnetism in steel for magnets is increased by the addition of

Q.45.

The hardest material just prior to diamond in Mho's scale is

Q.46.

The main purpose of galvanising iron sheets is to

Q.47.

Ceramic recuperators are generally made of

Q.48.

Zinc is not used

Q.49.

Refined acetic acid storage vessel are made of

Q.50.

The behaviour of visco-elastic material is time dependent. This behaviour is common in __________ materials.