Q.1.

Which of the following reactions is undesirable in the production of catalytically reformed gasoline ?

Q.2.

'Solvent naphtha' used mostly as a solvent in paints and perfumery is produced by the __________ of virgin naphtha into small boiling range cuts.

Q.3.

True vapour pressure of a petroleum fraction __________ Reid vapour pressure.

Q.4.

Increase in the specific gravity of petroleum products indicates

Q.5.

Cetane number of alpha methyl naphthalene is assumed to be

Q.6.

Petroleum deposits are detected by the.

Q.7.

Which one is preferred for aircraft engine ?

Q.8.

Feedstock for polymerisation is

Q.9.

__________ base crude oil is also called asphaltic crude.

Q.10.

Which of the following is the most important property for a jet fuel ?

Q.11.

Thermofer catalytic cracking process is a __________ process.

Q.12.

Pressure & temperature maintained in catalytic cracking is about

Q.13.

Pick out the wrong statement.

Q.14.

Products drawn from the top to bottom of the crude oil distillation column has progressively increasing

Q.15.

Good quality kerosene should have

Q.16.

The most suitable solvent for deasphalting vacuum residue is

Q.17.

Which of the following has the highest flash point of all ?

Q.18.

Hydrocracking employs

Q.19.

Which of the following processes is used for the production of petroleum coke ?

Q.20.

Quinoline is a/an __________ compound.

Q.21.

Methyl tertiary butyl ether (MTBE), a high octane (octane no. =gasoline blending component is produced by the simple additive reaction of isobutylene with

Q.22.

LPG when brought to atmospheric pressure & temperature will be a

Q.23.

Pick out the correct statement pertaining to catalytic cracking.

Q.24.

Platforming is a __________ process.

Q.25.

Which parameter is used for the grading of paraffin waxes ?

Q.26.

1 centistoke is equal to __________ Redwood I seconds.

Q.27.

Char value of Kerosene is the amount of charred oil deposition on the wick obtained after burning it in a standard wick lamp at a standard rate forhours. Char value of a good quality kerosene should be less than __________ mg/kg of kerosene.

Q.28.

Asphalts are

Q.29.

Paraffins are desirable in lubricating oil, as it has got high

Q.30.

The characterisation factor of crude petroleum oil is around

Q.31.

Sour crude means the __________ bearing crude.

Q.32.

Crude oils containing more than __________ kg of total salts (expressed in terms of NaCl) per thousand barrel is called a 'salty crude'.

Q.33.

Performance number of a liquid fuel is related to its

Q.34.

Pick out the correct statement.

Q.35.

Which of the following is a naphthene ?

Q.36.

Aromatics have the highes __________ of all the hydrocarbons of same carbon atoms.

Q.37.

Higher boiling fractions like atmospheric residue is distilled under vacuum at low temperature because at high temperature, there is a tendency of the predominance of

Q.38.

Highest quality bitumen is produced from the __________ crude oil.

Q.39.

Smoke point of kerosene is the

Q.40.

Cetane number of a diesel fuel is the measure of its

Q.41.

Aniline point of the diesel is a measure of its __________ content.

Q.42.

Reid vapour pressure of gasoline is the measure of its

Q.43.

Naphtha yield in straight run distillation of crude oil may be about __________ percent.

Q.44.

Crude petroleum oil is a __________ fuel.

Q.45.

Molecular weight of crude oil is in the range of

Q.46.

Which is the most ideal feed stock for 'coking' process used for the manufacture of petroleum coke ?

Q.47.

The conductivity of crude oil-water mixture depends on the

Q.48.

Which parameter is used for the grading of paraffin waxes ?

Q.49.

Presence of sulphur in gasoline

Q.50.

Which of the following additives improves the cetane number of diesel ?