Q.1.
The stone masonry of finely dressed stones laid in cement or lime, is
Q.2.
The form work from the sides of beams can be removed only after
Q.3.
The form work from the underside of slabs, can be removed only after
Q.4.
The lower half portion between crown and skew back of the arch, is called
Q.5.
A floor constructed with 3 mm marble chips, is known
Q.6.
The size of a floor tile commonly used, is
Q.7.
The art of bringing the floor to a true level surface by means of screeds, is called
Q.8.
The pile provided with one or more bulles in its vertical shaft, is generally known as
Q.9.
Under reamed piles are generally used for
Q.10.
To support a heavy structure in sandy soil, the type of foundation generally used, is
Q.11.
A temporary rigid structure having platforms to enable masons to work at different stages of a building, is known as
Q.12.
The lower edge of the pitched roof, from where the rain water of the roof surface drops down, is known as
Q.13.
The inner section of a cavity wall, is generally known as
Q.14.
The 19 cm × 9 cm side of a brick as seen in the wall face, is generally known as
Q.15.
A floor constructed with the 4 to 6 mm marble chips, is known
Q.16.
As compared to English bond, double Flemish bond is
Q.17.
In case of Raymond pile
Q.18.
A roof which slopes in four directions, is called
Q.19.
In any good staircase, the maximum and minimum pitch respectively should be
Q.20.
The concrete slump recommended for columns, is
Q.21.
The minimum strength of the mortar used in load bearing brick masonry, is
Q.22.
Which one of the following piles has a cast iron shoe even after removal of the hollow cylindrical steel casing?
Q.23.
The strength of brick masonry in 1:6 cement mortar, is
Q.24.
Auger boring
Q.25.
The bearing capacity of a water logged soil, may be improved by
Q.26.
The voussoir placed at crown of an arch, is known as a
Q.27.
The nominal thickness of one brick wall in mm, is
Q.28.
The depth of the ground water table may be ascertained by
Q.29.
The form Work including the props can be removed from beams, only after
Q.30.
The black cotton soil
Q.31.

In verandah floors outward slope is

Q.32.

Dampness causes

Q.33.

In horizontal D.P.C, thickness of cement concrete (1 : 2 :is

Q.34.

In case of Raymond pile

Q.35.

Queen closer may be placed

Q.36.

Dado is usually provided in

Q.37.

The foundation in which a cantilever beam is provided to join two footings, is known as

Q.38.

The foundations are placed below ground level, to increase

Q.39.

The exterior angle between outer faces of a wall, is known as

Q.40.

The taper of precast concrete pile should not be more than

Q.41.

A solid core of rock is formed in side the cylinder in the case of

Q.42.

Stud(s) of a common wooden partition

Q.43.

The angular steps used for changing direction of the stairs, are called

Q.44.

Pick up the incorrect statement from the following :

Q.45.

Grillage foundation

Q.46.

The loose pockets in soil mass can be bridged safely by providing a raft foundation provided the soft area is smaller than

Q.47.

The under surface of an arch, is called

Q.48.

The single stage well point system of dewatering an excavation can be used if the depth of excavation does not exceed

Q.49.

Pick up the correct statement from the following :

Q.50.

During percussion drilling