Q.1.

Teak wood is suitable for

Q.2.

Plastic

Q.3.

Vanadium steel is generally used for

Q.4.

If the furnace is provided with insufficient fuel at low temperatures, the type of pig iron produced, is called

Q.5.

Sewer pipes are made of

Q.6.

Fibre glass

Q.7.

Due to attack of dry rot, the timber

Q.8.

Brittleness of cold is due to an excess of

Q.9.

In a mortar, the binding material is

Q.10.

Pick up the correct statement from the following: Method of sawing timber

Q.11.

Black marble is generally found in the district of

Q.12.

Which one of the following is an air binding material ?

Q.13.

Galvanising means covering iron with a thin coat of

Q.14.

Bitumen felt

Q.15.

Initial setting time of cement for asbestos cement products should be not less than

Q.16.

The rocks which are formed due to cooling of magma at a considerable depth from earth's surface are called

Q.17.

Kaolin is chemically classified as

Q.18.

Pick up the correct statement from the following:

Q.19.

Stainless steel contains

Q.20.

The slag which floats on the surface of the molten iron generally contains

Q.21.

The filler used in plastic bitumen, is

Q.22.

Pick up the correct statement from the following:

Q.23.

For the manufacture of Portland cement, the proportions of raw materials used, are

Q.24.

Lacquer paints

Q.25.

Wrought iron contains carbon upto

Q.26.

Clay and silt content in a good brick earth must be at least

Q.27.

The most fire resistant paints are :

Q.28.

A good quality stone absorbs water less than

Q.29.

For preparing porcelains, the clay should be

Q.30.

In the method of condensation polymerization,

Q.31.

The variety of pig iron used for the manufacture of steel by Bessemer process, is

Q.32.

Quartzite is a

Q.33.

The process of manufacturing steel by heating short lengths of wrought iron bars mixed with charcoal in fire clay crucibles and collecting the molten iron into moulds, is known as

Q.34.

Pick up the hypabyssal rock from the following:

Q.35.

Depending on the chemical composition and mechanical properties, iron may be classified as

Q.36.

Minimum ofof iron, is available in

Q.37.

For the manufacture of plywood, veneers are placed so that grains of adjacent veneers

Q.38.

Apiece of sawn timber whose cross-sectional dimensions exceed 5 cm, in one direction andcm in the other direction, is called a

Q.39.

Inhaling of fly-ash over a long period causes

Q.40.

The commonly used lime in white washing, is

Q.41.

Resins are

Q.42.

Refractory bricks are used for

Q.43.

Pick up the correct statement from the following:

Q.44.

Asbestos cement

Q.45.

Pick up the polymineralic rock from the following:

Q.46.

Bessemer process is used for the manufacture of

Q.47.

The portion of the brick without a triangular corner equal to half the width and half the length, is called

Q.48.

If P is the percentage of water required for normal consistency, water to be added for determination of initial setting time, is

Q.49.

Pick up the correct statement from the following:

Q.50.

Polymerization helps to improve the property of