Q.1.

A steel beam supporting loads from the floor slab as well as from wall is termed as

Q.2.

The centre of pressure of a liquid on a plane surface immersed vertically in a static body of liquid, always lies below the centroid of the surface area, because

Q.3.

Width of carriage way for a single lane is recommended to be

Q.4.

Compaction by vibratory roller is the best method of compaction in case of

Q.5.

Storage coefficient of a compressible confined aquifer is a function of

Q.6.

In a reinforced concrete beam-column, the increase in the flexural strength along with the increase in the axial strength occurs

Q.7.

A linear relationship is observed between speed and density on a certain section of a highway. The free flow speed is observed to bekm per hour and the jam density is estimated asvehicles per km length. Based on the above relationship, the maximum flow expected on this section and the speed at the maximum flow will respectively be

Q.8.

While deriving an expression for loss of head due to a sudden expansion in a pipe, in addition to the continuity and impulse-momentum equations, one of the following assumptions is made :

Q.9.

The standard plate size in a plate bearing test for finding modulus of subgrade reaction (k) value is

Q.10.

The sequent depth ratio of a hydraulic jump in a rectangular horizontal channel is 10.The Froude Number at the beginning of the jump is :

Q.11.

The main constituents of gas generated during the anaerobic digestion of sewage sludge are :

Q.12.

Mud pumping is commonly associated with

Q.13.

Biochemical oxygen demand (BOD) of waste water is a measure of

Q.14.

The penetration test for bitumen is conduced at a temperature of

Q.15.

The unit weight of a soil at zero air voids depends on :

Q.16.

For an anisotropic soil, permeabilities in x and y directions are kx and ky respectively in a two dimensional flow. The effective permeability keq for the soil is given by

Q.17.

The most commonly used sampler for obtaining a disturbed sample of the soil is

Q.18.

The shape of the cross-section, which has the largest shape factor, is

Q.19.

Factor of safety adopted by IS :-while arriving at the permissible stress in axial compression, is :

Q.20.

The expression for the specific speed of a pump :

Q.21.

The group efficiency of a pile group

Q.22.

The ratio of unconfined compressive strength of an undisturbed sample of soil to that of a remoulded sample, at the same water content, is known as :

Q.23.

Two samples of water A and B have pH values of 4.4 and 6.4 respectively. How many times more acidic sample A is than sample B ?

Q.24.

The most important water quality parameter for domestic use of water is

Q.25.

The BOD removal efficiency, in percentage, during primary treatmet under normal conditions is about

Q.26.

Chemical oxygen Demand (COD) of a sample is always greater than Biochemical Oxygen Demand (BOD) since it represents :

Q.27.

The unit of dynamic viscosity of a fluid is

Q.28.

The temporary hardness of water, is caused by:

Q.29.

Well foundations are commonly used as foundations for the following structures :

Q.30.

The plan of stairs supported at each end by landings spanning parallel with risers is shown in the below figure. The effective span of staircase slab is