Q.1.

For solving network problems of pipes, necessary condition is

Q.2.

Orifice-meter is used to measure

Q.3.

Hydraulic radius is equal to

Q.4.

Flow in pipes is laminar if Reynold number is

Q.5.

When water flows over a rectangular suppressed weir, the negative pressure created beneath the nappe

Q.6.

Pick up the correct statement from the following :

Q.7.

To avoid the tendency of separation of liquid flow, the most suitable ratio of the diameters of the throat and the pipe, is

Q.8.

The discharg formula Q = Cd 2gH x A is used for rectangular

Q.9.

If jet of water coming out from a nozzle with a velocity 9.m/s, the angle of elevation being 30°, the time to reach the highest point is

Q.10.

To avoid the tendency of separation of liquid flow, the most suitable ratio of the diameters of the throat and the pipe, is

Q.11.

In a fluid flow a particle may posses

Q.12.

Barometres are used to measure

Q.13.

The ratio of inertia force of a flowing fluid and the viscous force of the liquid is called :

Q.14.

Atmospheric pressure varies with

Q.15.

Discharge over an ogee weir remains the same as that of

Q.16.

From a nozzle exposed to atmosphere, the liquid jet traverses

Q.17.

The discharge through amm diameter external mouth piece fitted to the side of a large vessel is 0.m3/s. The head over the mouth piece is

Q.18.

In two dimensional flow the components of velocity are given by u = ax; v = by. The stream lines will be

Q.19.

In flow, the liquid particles may possess

Q.20.

For most economical rectangular section of a channel, the depth is kept

Q.21.

The magnitude of water hammer in a pipe depends upon

Q.22.

Dimensions of the dynamic viscosity (μ) are

Q.23.

When no air is left below the nappe and water stream adheres to the down stream face of the weir, it is known as

Q.24.

To avoid the force of surface tension in an inclined manometer, the minimum angle of inclination is

Q.25.

The acceleration f required to accelerate a rectangular tank containing water horizontally so that the slope of its free surface is 45°, is

Q.26.

If cohesion between the molecules of a fluid is more than adhesion between the fluid and glass, the free level of fluid in a dipped glass tube will be

Q.27.

The discharge through a V-notch weir varies as

Q.28.

Euler's equation for the motion of liquids assumes that

Q.29.

In a centrifugual pump casing, the flow of water leaving the impeller, is

Q.30.

Water belongs to