Q.1.

A triangle used for turning the face of locomotives, consists of

Q.2.

Coning of wheels is provided

Q.3.

Gauge of a permanent way, is

Q.4.

On Indian Railways standard length of rails for M.G. track, is

Q.5.

For providing the required tilt of rails, adazing of wooden sleepers, is done for

Q.6.

In India, metre gauge permanent way was adopted in

Q.7.

For an effective administration, Indian railway system has been divided into

Q.8.

In a railway track, permissible gauge with tolerance under loaded condition, is

Q.9.

Pick up the incorrect statement from the following. Required tilt of 1 inis provided

Q.10.

Pick up the correct statement from the following:

Q.11.

In permanent way, ballast

Q.12.

Ballast packed below and around the sleepers to transfer the load from sleepers to formation, generally consists of

Q.13.

Top surface of steel sleepers, is

Q.14.

Degree of a railway curve is defined as number of degrees subtended at the centre of a curve by an arc of

Q.15.

A mono-block sleeper has

Q.16.

Minimum length of a transition curve required for

Q.17.

Pick up the correct statement from the following:

Q.18.

By interchanging gibs and cotters of a pot sleeper, gauge may be slackened by

Q.19.

For even distribution of load through ballast, load dispersal is assumed as

Q.20.

If D is the distance between parallel tracks G is the gauge and α is angle of crossings, the distance between theoretical noses of two crossings measured parallel to tracks, is

Q.21.

On Broad Gauge main lines with maximum traffic loads, the rail section preferred to, is

Q.22.

For inspection and packing of ballast, each pot sleeper is provided with

Q.23.

In Indian railways, plate laying is usually done by

Q.24.

Wing rails are provided

Q.25.

Monnier, the inventor of R.C.C., suggested the introduction of reinforced cement concert sleepers for the railways in

Q.26.

A scissors cross over consists of one diamond and

Q.27.

For calculating the length of curve lead (C.L.), the correct formula is

Q.28.

The life of a wooden sleeper depends upon

Q.29.

On a single line track,goods trains loaded with iron ore run from A to B and empty wagons return from B to A daily. Amount of creep of the rails will be

Q.30.

A turn-in-curve is defined as