Q.1.
Actuators are used to:
Q.2.
Plotter accuracy is measured in terms of repeatability and:
Q.3.
Which of the following elements can be used with a TI510 FC?
Q.4.
For a type 0 system, the steady-state:
Q.5.
An assembly language instruction:
Q.6.
The lowest form of computer language is called:
Q.7.
CAE and CAM are linked through:
Q.8.
The chosen language for the Japanese Fifth-Generation Compu-ter Project is:
Q.9.
When a computer fetches an instruction, the binary code representing the instruction appears on the:
Q.10.
A stepping motor;
Q.11.
A microprocessor is:
Q.12.
An up/down counter used in a TI510PC has three inputs. Which of the following is not one of them?
Q.13.
A pick-and-place manipulator is:
Q.14.
FORTRAN is:
Q.15.
A smart solid-state sensor is:
Q.16.
D/A (digital to analog) conversion:
Q.17.
Which of the methods below can be used to tell a robot what it is to do?
Q.18.
The processing, which normally consists of a small computer with one or more peripheral devices, connected via a high-speed line to the large control computer is known as
Q.19.
Most data transmission in the future will be:
Q.20.
The integrated circuit:
Q.21.
The parallel register:
Q.22.
Microcomputer-based control sys-tems
Q.23.
VLSI (very large scale integrated circuits) logic:
Q.24.
A typical NC system has which of the following components?
Q.25.
The basic difference between broadband and baseband is:
Q.26.
Which part of the system allows the user to interact with the compiler? (a) Memory
Q.27.
What is offset error?
Q.28.
A thermistor:
Q.29.
The steady-state error is:
Q.30.
The robot: