You are the administrator of a WindowsServer network that runs in mixed mode. You install a new WindowsServer computer. You create and share a new HP LaserJetprinter. Your WindowsProfessional client computers can print to the new printer successfully. However, when users try to connect to the printer from Windows NT Workstation 4.0 client computers, they receive the dialog box shown in the exhibit. "The server on which the printer resides does not have a suitable HP LaserJet printer driver installed". You want the printer driver to be installed automatically on the Windows NT Workstation computers. What should you do?

Your computer has a mirrored volume and you wish to now install the Recovery Console for future troubleshooting. How do you do this?

You are the administrator of a WindowsServer computer. The server has a single hard disk with a single NTFS partition. You use a third-party tool to add a new partition to the disk. When you restart the server, you received the following error message: "Windowscould not start because the following file is missing or corrupt: \system32\ntoskrnl.exe. Please re-install a copy of the above file." What should you do to resolve the problem?

You are configuring a WindowsServer computer as a Routing and Remote Access server for a Branch office. You discover that an incorrect driver was installed during the installation of the modem. You attempt to remove the modem by using Phone and Modem Options in Control Panel. After each attempt to remove the modem by using this method, the computer stops responding. You restart the computer again. You must install the correct driver for the modem as quickly as possible. What should you do?

You are the administrator of a WindowsServer computer. The server hosts several web sites that have logging enabled. You use a third-party reporting utility to analyze the log files produced by the web sites. You notice that all data from 7:00pm to midnight each night is included in the following day's logfile. You want all data to be included in the correct day's log file. What should you do?

You are the administrator of a WindowsServer computer that has one hard disk. This computer runs a custom application that writes a large number of small temporary files in a single directory to support request from client computers. To improve performance of the application, you add three new 100-GB SCSI disks to the server to hold these temporary files. You want to ensure that the application can use allGB of space with a single drive letter. You also want to ensure the fastest possible performance when writing the temporary files. How should you configure the three disks?

You are the administrator of the WindowsServer network shown in the exhibit. Users in the Research group and the Executive group have permission to access the Internet through a WindowsServer computer running Microsoft Proxy Server. These users must enter their proxy server user names and passwords to connect to the proxy server, to the Internet, and to your local intranet server. The users who do not access the Internet do not have user accounts on the proxy server and, therefore, cannot connect to the intranet server. You want all users to be able to connect to the intranet server without entering a separate user name and password. What should you do?

You are the administrator of your company's network. You are configuring the security policy for a group of users in the finance organizational unit (OU). You need to configure a group policy so that future changes to group policy will be applied withinminutes to any computers that are log on to the network. What should you do?

Your company's network includes Windows 3.1 client computers, Windowsclient computers, and WindowsProfessional client computers. The company's manufacturing facilities runhours per day. The company has developed its own 32-bit application that collects information from the manufacturing process so that workers on one shift can find out that was manufactured during the previous shift. The company wants to make the application available on all of the client computers by using Terminal Service on a WindowsServer computer. This server will not run as a domain controller. You install Terminal Services. The information technology (IT) department needs to be able to remote control users' sessions to support and troubleshoot the application. What should you do to enable the IT department to control users' sessions?

Your WindowsServer computer uses a non-Plug and Play ISA modem configured to use IRQYou add a PCI modem and restart the computer. Device Manager reports an IRQ conflict between the two modems. Both modem are trying to use IRQYou want to resolve the problem. What should you do?

You are a network administrator for your company. The company is currently configuring its branch offices with a WindowsServer computer at each office. Each branch office has a technical-support department but not a network administrator. You want to configure the remote WindowsServer computers so that whenever a new Microsoft driver becomes available, the branch offices are notified automaticaly when the administrator logs onto the server. What should you do?

You want to improve the TCP transmission speed of a WindowsServer computer. You also want to remove an unused registry key. You use Regeditto edit the registry of the WindowsServer. You insert a value in the registry named TCPWindowSize, and you remove the unused key. You restart the computer, but the computer stops responding before the logon screen appears. You want to return the computer to its previous configuration. What should you do?

You are the administrator responsible for security and user desktop settings on your network. You need to configure a custom registry entry for all users. You want to add the custom registry entry into a Group Policy object (GPO) with the least amount of administrative effort What should you do?

You are the administrator of WindowsServer computer. Your computer has a span volume that consists of areas on three physical hard disks on the server. The three disks support hot swapping. You regularly backup the span volume by using windows backup. One of the disk fail, you replace the disk with a new un-partitioned disk. You want to recover the span volume and disk data as soon as possible. What should you do?

You are the administrator of a WindowsServer computer that has FIVE hard disks. FourGB hard disks on the server are configured as a single stripe volume. You want to reconfigure the fourth disk so that the volume is fault tolerant and has as much space possible available for storing data. You want to use only existing hardware. What should you do?

Your network containsdomain controllers,member servers, and approximately 1,client computers. All the servers run WindowsServer, and all the client computers run WindowsProfessional. Two of the domain controllers act as DNS servers. Users of client computers use file sharing to grant access to files stored locally. The network hassubnets and uses TCP/IP as the only network protocol. You want to configure the network so that all computers can resolve the addresses of all other computers by using DNS. Client computers must be able to register and resolve addresses if a server fails. How should you configure the DNS servers?

You are the administrator of contoso.local domain. You organize the domain into organizational units as shown in the EXHIBIT. You configure the local security options and other settings for the default domain policy object You delegate administration of Michigan and Florida OU. You want to prevent those administrators from creating any other group policy objects with settings that conflict with those you configured.What should you do?

Your network contains NetWare 4.0 Servers. You have successfully installed Client Service for NetWare on WindowsProfessional computers, and Gateway Service for NetWare on WindowsServer Computers. You recently added a new WindowsServer computer to the network and installed Gateway Service for NetWare on it. However, the server is unable to connect to any NetWare servers. What should you do on the new WindowsServer computer to resolve this problem?

Some applications on your company network use defined domain user accounts as their service accounts. Each computer that runs one of these applications should have the respective service account in the Local Administrators Group. Currently, you individually place these service accounts in the Local Administrators Group on the appropriate WindowsProfessional computers. You need to centralize this process. What should you do?

Your network consists of Windowsfile servers, Windowsprint servers, Windowsprofessional computers, Windowsfile servers. You must prevent any unsigned drivers from being installed on any computer in your Windowsnetwork. What should you do?

You want to provide complete redundancy for all data stored on your hardware RAID 5 array. You install second h/w RaidYou want to create a mirror set of the original array. However when you right click the free space on new array you see no option to create a new volume or mirrrored volume. What should you do?

You have configured a Group Policy Object (GPO) for the marketing oranization unit (OU) to prevent users from accessing My Network Places and from running System in Control Panel. You want the Managers Domain Local Group to be able to access My Network Places, but you still want to prevent them from running System in Control Panel. What should you do?

You are the administrator of a network that consists of WindowsServer computers and WindowsProfessional computers. You want to configure the deployment of the most recent Windowsservice pack so that users of the WindowsProfessional computers receive the service pack automatically when they log on to the domain. What should you do?

You are the network administrator for your company. The company has numerous branch offices, and each office uses Internet Connecting Sharing to connect to the Internet. A new employee named David Johnson is configuring a WindowsServer computer as a file server. When David uses Windows update for the first time and select Product Update, he receives an error message stating that access is denied. David needs to be able to update the file by using his account. What should you do?

You are the administrator of a WindowsServer computer. The server contains one network adapter and is a file and print server for critical company resources. You install a second network adpater in the server and connect it to the same network subnet as the first adapter. You want to ensure that the first adapter is used for all network traffic and the second adapter is used only if the first adapter fails or is disconnected from the network. You also want to ensure that the server always has network connectivity even if one network adapter fails. What should you do?

You enable the Routing and Remote Access Service (RRAS) on a computer running WindowsServer. You configure the computer as a RAS server. You want to provide mutual authentication between the RAS server and RAS clients. You also want to ensure that data passing between the RAS server and RAS clients is encrypted. Which authentication method should you use for your incoming connections to support mutual authentication and data encryption?

You install Terminal Services on a Windowsdomain controller. You install Terminal Services Client on users' client computers. Users report that when they try to connect to the Terminal server, they receive the following error message: "The local policy of this system does not allow you to logon interactively." When you attempt to log on to the Terminal server as an administrator from a user's computer, you log on successfully. You want users to be able to log on to the Terminal server. What should you do?