Q.1.
For determining the bearing capacity of soil, in method of loading the size for a square steel plate used is about ________
- a) 300 mm2 to 750 mm2
- b) 3000 mm2 to 7500 mm2
- c) 3 m2 to 75 m2
- d) 3 mm2 to 75 mm2
Q.2.
In method of loading, which material is used for loading?
- a) Wooden pegs
- b) Square steel plate
- c) Sand bags
- d) Rocks
Q.3.
The bearing capacity of sandy soil and gravelly soils is affected to the extent of ___________% by the presence of water table.
- a) 50
- b) 10
- c) 25
- d) 80
Q.4.
Due to the adjustment of soil particles under the action of loading, there is some settlement at zero loading, this is known as the ___________
- a) Bearing capacity
- b) Safe bearing capacity
- c) Vibroflotation
- d) Zero correction
Q.5.
The loading to the test plate is applied with the help of ______
- a) Sand bags
- b) Hydraulic jack
- c) Wooden pegs
- d) Hard rocks
Q.6.
In analytical methods, which soil parameters used to determine the ultimate bearing capacity of the soil?
- a) Angle of internal friction
- b) Permeability
- c) Adhesion
- d) Porosity
Q.7.
In Penetration test, the formula obtained for the safe bearing capacity of soil per unit area is given by?
- a) R÷{A×F}
- b) R-{A×F}
- c) R+{A×F}
- d) R×{A×F}
Q.8.
Identify the method given below.
- a) Plate load test
- b) Method of loading
- c) Analytical method
- d) Penetration test
Q.9.
Identify the method given below.
- a) Penetration test
- b) Method of loading
- c) Plate load test
- d) Analytical method
Q.10.
Which method for determining the bearing power of soil is most preferred among the given below?
- a) Method of loading
- b) Plate load test
- c) Penetration test
- d) Analytical method