Once you have stopped as a part of the stop/start maneuver during the on-road driving skills test, you must activate your four-way flashers and shift into neutral or park. You must not block any driveways, intersections, fire hydrants, or signs.

The danger zones of a school bus are areas in which children are most likely to be hit, either by another vehicle or by the bus itself. Such areas are located to the front, sides, and rear of a bus. Danger zones can extend 10 feet from every side of a bus.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading. The process must be properly supervised and done with care.

At a stop, a school bus should be stopped with the front bumper at least 10 feet away from the students. This forces the students to walk toward the bus, allowing the driver to keep an eye on their movements.

If students are evacuated due to a school bus being in the direct path of a sighted tornado, the driver should lead them to shelter in a nearby building. If no such shelter is available, the driver should escort them to a nearby ditch or culvert. They should avoid areas that may be subject to flash flooding and should be far enough away from the bus that it would not fall on them if it tipped over.

The driver of a school bus should observe students as they enter or exit the bus to ensure that they are not caught in the door or handrails. It is also important to make sure the students have moved a safe distance away from the unloading area after they have exited the bus.

You must drive in a safe and responsible manner during the on-road driving test. This includes wearing your safety belt; obeying all traffic signs, signals, and laws; and completing the test without an accident or moving violation.

If students are evacuated due to a school bus being in the direct path of a sighted tornado, the driver should lead them to shelter in a nearby building. If no such shelter is available, the driver should escort them to a nearby ditch or culvert. They should avoid areas that may be subject to flash flooding and should be far enough from the bus that it would not fall on them if it tipped over.

It is essential that school bus drivers check all of the bus's mirrors before operating the vehicle. You should always have a maximum viewing area that is consistent with Federal Motor Vehicle Safety Standards. If necessary, have the positioning of the mirrors adjusted.

As a part of earning your CDL, you will have to pass an inspection test and demonstrate that your vehicle is safe for operation. During the vehicle inspection test, you will have to walk around the vehicle and point to or touch each item and explain to the examiner what you are checking and why. You will not have to crawl under the hood or under the vehicle.

School bus drivers should approach stops slowly and cautiously.

If a school bus becomes stalled or trapped on railroad tracks, the driver should get everyone out of the bus and off of the tracks immediately. The driver and students should move away from the tracks at an angle and in the direction of any oncoming train.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading. The process must be properly supervised and done with care.

During the on-road driving test, the examiner will be score you on specific driving maneuvers as well as on your general driving behavior. You must drive in a safe and responsible manner; obey all traffic signs, signals, and laws; and not cause an accident or commit a moving violation.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

The function of an Anti-Lock Braking System (ABS) is to prevent a vehicle's wheels from locking up when the driver brakes hard on a slippery surface.

After students have exited a bus at a school, the driver should walk through the bus to check for any remaining students who are hiding or sleeping. Drivers should also look out for items that students may have left behind.

On a school bus, the overhead inside rearview mirror is used to monitor passenger activity inside the bus.

During emergency situations, it is usually safest for students to remain on a school bus. Evacuations are mandatory if the bus has stalled on railroad tracks, if the bus is on fire or there is a threat of fire, or if there is a hazardous materials spill. Students should be evacuated any time there is imminent danger of collision.