When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

If your on-road driving test route does not include a railroad crossing, you may be asked to explain and demonstrate the proper railroad crossing procedures to the examiner at a simulated location.

You may be asked to complete a parallel parking maneuver into a parking space that is to the left of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

If a student tries to retrieve a dropped object, they may disappear from the driver's line of sight. This is potentially very dangerous. Rather than retrieve dropped items themselves, students should move to a point of safety outside of the bus's danger zones, get the driver's attention, and wait for the driver to retrieve what has been dropped.

A school bus's long sides are vulnerable to being pushed by winds. If you must drive in windy conditions, you should maintain a strong grip on the steering wheel, try to anticipate wind gusts, and slow down. If necessary, contact your dispatcher for instructions on how to proceed.

The adjustment of mirrors should be checked prior to the start of any trip.

The function of an Anti-Lock Braking System (ABS) is to prevent a vehicle's wheels from locking up when the driver brakes hard on a slippery surface.

During the on-road driving test, do not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

It is critical to the safe operation of a school bus that mirrors be properly adjusted. Always check each mirror before operating the bus.

If a school bus is on fire, or if there is a threat of fire, it is mandatory for a bus driver to evacuate the students from the bus.

On a school bus, the overhead inside rearview mirror is mounted directly above the windshield on the driver’s side of the bus. This mirror should be used to monitor students inside the bus.

The process of loading or unloading students from a school bus requires a driver's full concentration. If there is a behavioral issue on the bus, wait until the exiting students are safely off the bus and out of the way before you address the problem on the bus.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

An encroachment during the basic vehicle control skills test is when an exercise boundary line is touched or crossed by any portion of the applicant's vehicle. Every encroachment will be counted as an error.

Railroad crossings that do not have any kind of traffic control device are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

Properly adjusted flat mirrors on a school bus should allow the driver to see 200 feet behind the bus, the base of each rear wheel, and the sides of the bus.

You should finish each exercise with your vehicle in the exact position described by the examiner. You can be penalized for failing to complete an exercise exactly in the manner described by the examiner, potentially resulting in failure of the basic control skills test.

During the pre-trip vehicle inspection test, you will be asked to check the power steering, water pump, alternator, and air compressor belts, if the vehicle is equipped.

Students should board a school bus slowly and in a single-file line. For safety, boarding students should use the handrail.

In a school bus, the overhead rearview mirror is mounted directly above the windshield on the driver’s side.