Wheels or rims that have had welding repairs should never be used.

If a vehicle has anti-lock brakes on just one axle, the driver will still have more control during braking than they would without any anti-lock brakes.

To reduce the risk of developing aggressive driving behavior, you should take measures to manage your stress. One strategy to do this is to simply take a deep breath and accept your circumstances if you realize you will be late to your destination.

Texting while driving is particularly dangerous because it is both a mental and physical distraction to the driver. In addition to diverting a driver's mental attention away from the road, texting requires a person to remove at least one hand from the vehicle's controls.

After changing a tire, you should stop a short distance later to recheck the tightness of the tire's lug nuts.

If you need to back your trailer but cannot back up in a straight path, you should back on a curved path toward the driver's side of the vehicle. This will allow you the best possible visibility while backing.

Rust around wheel nuts may mean that they are loose. Check the tightness of the nuts if you see any rust in the area.

If your brakes fail while you are driving downhill, you should first look for an escape ramp to stop your vehicle. If no ramp is available, you should look for an alternative place to bring your vehicle to a stop, such as an open field or side road that flattens out or turns uphill.

When backing with a trailer, begin by turning the steering wheel in the direction opposite of the turn. Once the trailer starts to turn, reverse the direction of the steering wheel to follow the trailer.

When driving a vehicle with ABS, you should brake in the same manner as you would in a vehicle without ABS.

A dual air brake system is made up of two separate air brake systems. The systems share a single set of brake controls, but each has its own air tanks, hoses, and lines. One system typically operates the regular brakes on the rear axle or axles while the other system operates the regular brakes on the front axle.

Rollovers are caused by operators turning too fast. To avoid rolling over, drive slowly on entrance ramps, on exit ramps, and around corners. Avoid making quick lane changes when towing trailers.

When approaching your vehicle before an inspection, make note of its general condition and ensure that it is not damaged or leaning. Look under the vehicle for fresh leaks of oil, grease, or fuel. Check around the vehicle for hazards to movement, such as people, other vehicles, or low-hanging wires or tree limbs.

If you are not sure which kind of extinguisher should be used on a fire in your vehicle, particularly a hazardous materials fire, you should wait for the firefighters to arrive and allow them to extinguish it.

If you see a crash involving an aggressive driver, you should stop a safe distance from the crash scene, wait for police to arrive, and inform them of the aggressive behavior you witnessed.

When making a left turn, you should wait until you reach the center of the intersection before actually beginning to turn. Due to off-tracking, the left side of your vehicle could hit another driver if you begin turning too early.

In vehicles equipped with an automatic tractor protection valve, the valve will pop out if air pressure drops to a level between 20 and 45 psi. When the valve pops out, the protection valve will close, stopping the flow of air.

The trailer hand valve, also called the trolley valve or Johnson bar, is used to work the trailer brakes. It should be used only to test the brakes. Using it while a vehicle is in motion could cause a skid.

Pre-trip inspections should be conducted in the same way every time. This will reinforce the steps, making it less likely that you will forget to inspect something important.

When braking, push the pedal down gradually to ensure that the vehicle comes to a smooth, safe stop.