In a school bus, the overhead rearview mirror is mounted directly above the windshield on the driver’s side.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading. This process should never take place without being properly supervised.

The function of an Anti-Lock Braking System (ABS) is to prevent a vehicle's wheels from locking up when the driver brakes hard on a slippery surface.

It is critical to the safe operation of a school bus that mirrors be properly adjusted. Always check each mirror before operating the bus.

During the on-road driving test, if your route does not include a railroad crossing, the examiner may ask you to explain and demonstrate the necessary procedures at a simulated location.

During the on-road driving test, do not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

You should always check the adjustment of all your mirrors before operating a school bus.

School bus drivers may only pick up students at official stops designated by authorized school officials.

During the on-road driving test, the examiner will be score you on specific driving maneuvers as well as on your general driving behavior. You must drive in a safe and responsible manner; obey all traffic signs, signals, and laws; and not cause an accident or commit a moving violation.

If a school bus is on fire, or if there is a threat of fire, it is mandatory for a bus driver to evacuate the students from the bus.

On a school bus, the overhead inside rearview mirror is mounted directly above the windshield on the driver’s side of the bus. This mirror should be used to monitor students inside the bus.

A pre-trip inspection should be completed in the same way before every drive. Consistency will help you learn all of the proper steps and decrease the likelihood that you will forget to check something.

The overhead inside rearview mirror of a school bus should be mounted directly above the windshield on the driver’s side of the vehicle. It should be used to monitor passenger activity inside the bus.

During the on-road driving test, you must not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

If a school bus becomes stalled or trapped on railroad tracks, the driver should get everyone out of the bus and off of the tracks immediately. The driver and students should move away from the tracks at an angle and in the direction of any oncoming train.

A school bus driver should load and unload students only at designated stops that have been approved by appropriate school district officials.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic vehicle control skills test.

When checking your vehicle's pedals during a pre-trip inspection, you should ensure that there is nothing under or around the pedals that will obstruct their use. Make sure the pedals are in proper working condition and that the surfaces of the pedals are grooved, if applicable.

If time permits, before deciding to evacuate a school bus, the driver should contact their dispatcher to explain the situation. The decision to evacuate must be a timely one.

Crossover mirrors are used to help a driver see the danger zone area directly in front of a school bus. The mirrors should also display the danger zone areas to the left and right sides of the bus, including the area from the front of the bus to the service door.