In conditions of poor visibility (such as at dawn, at dusk, in rain, or in snow), you should turn on your low beam headlights to make your vehicle easier to see. Do not use your high beams when driving near other vehicles.

Tires on the same vehicle should all be equally sized. Ensure your tires are not mismatched when inspecting your vehicle.

You should only sign a previous inspection report if defects were either noted and certified to have been repaired or if repairs were not needed.

A steering wheel with play of more than 10 degrees may be defective. On a 20-inch wheel, this is equal to about two inches of movement at the rim of the wheel.

The securement of cargo must be checked before beginning a trip, within the first 50 miles of a trip, and then again every three hours or 150 miles.

Hazardous materials must be diamond-shaped and a size of at least 10 ¾ square inches.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

During the on-road driving test, you must listen to and follow the directions given by the examiner. They will never ask you to drive in an unsafe manner.

After a trip, you may be required to perform an inspection and file a report on each vehicle that you've driven.

Speeding up too quickly on a road with poor traction could cause a driver to lose control of their vehicle. In conditions that cause poor traction, a driver should accelerate especially smoothly and gradually.

In the event of tire failure, hold the steering wheel firmly. Stay off the brakes and let the vehicle slow down on its own. Once the vehicle has slowed considerably, you should brake very gently, pull off the road, and stop.

Hydroplaning occurs when a vehicle's tires lose contact with the road surface and instead glide along on a film of water above the surface of the road.

A bus must always be inspected before it is driven. The inspection process must include a review of the inspection report made by the previous driver. You should operate the vehicle only if defects listed on the inspection report have been certified as repaired or as not needing to be repaired.

When accelerating, speed up smoothly and gradually so your vehicle does not jerk. Rough acceleration can cause mechanical damage.

It is safest not to drive in foggy areas. However, if you must drive through fog, you should slow down, use your low beam headlights and fog lights, and turn on your four-way flashers.

B and C type fire extinguishers are designed to work on electrical fires. Water should never be used to extinguish an electrical fire because doing so could result in an electrical shock.

Most good drivers consistently look down the road 12 to 15 seconds ahead of their vehicles. Watching ahead of your vehicle will allow you to react to upcoming hazards before meeting them.

Check all emergency exits before operating a bus. Never drive a bus with an open emergency exit door or window.

If stopped on the side of the road, you must place emergency warning devices, such as reflective warning triangles, within 10 minutes of stopping.

Black ice is a thin layer of ice that is clear enough for the road surface to be seen through it. A road covered in black ice may look like it is merely wet. You should be very careful when temperatures are below freezing and the road looks wet.