Warning signs prepare drivers for upcoming road conditions and hazards and are usually yellow with black markings. This sign tells drivers to be cautious when driving under conditions that may cause the roadway to become wet and slippery.

Pentagonal signs indicate that you are in a school zone. Be extra alert to children and pedestrians when driving near a school.

This sign indicates that a T intersection is ahead.

Be sure that seat belts are clean, in good condition, and available to all of your vehicle's occupants. In Minnesota, motor vehicles must be equipped with seat belts and the use of seat belts is mandatory.

Persons who are upset, angry, or otherwise distracted by their emotions should take time to cool off before driving a car. Taking out frustrations or anger while driving is exercising very poor judgment and is very dangerous to both the driver and others on the road.

This sign indicates that the road ahead curves to the right.

Warning signs are normally diamond-shaped and yellow, although orange warning signs are used in work areas. Such signs warn that you are approaching a hazardous location or an area where special rules apply.

If your vehicle breaks down on the highway, you should signal before carefully exiting the roadway and turning on your hazard flashers. Get as far off the road as possible and park in a location where other drivers can easily see you. Lift your hood to let other drivers know your vehicle is disabled.

You must not drive at a speed that is faster than is reasonable and prudent. You must drive at a speed that is appropriate for the area where you are driving, the type and condition of surrounding traffic, the presence of pedestrians, the weather, the quality of the road, and light conditions. You must drive within legal speed limits.

Diamond-shaped signs warn drivers of existing or potential driving hazards. You will usually see these signs in yellow or orange.

A steady red traffic light indicates that drivers must come to a complete stop. Driving through a red light is against the law and is extremely dangerous. Drivers may turn right on a steady red light if there is no sign prohibiting a turn on red.

This sign indicates that an intersection with a crossing road is ahead.

Yellow centerlines are used to separate traffic moving in opposite directions. Broken lines may be crossed to pass slower-moving traffic when it is safe to do so.

Blind spots are areas that a driver cannot see without moving their head. They can be located to the sides of and behind a vehicle.

All bicyclists have the same rights, duties, and responsibilities as drivers of motor vehicles. Motorists and bicyclists who do not obey traffic laws can be ticketed.

If a yellow panel with the message "Exit only" is on a highway sign, the lane below the sign will not continue through the interchange. Instead, the lane will go off of the roadway to form a ramp. If you are in a lane directly under an "Exit only" sign, you may change lanes to move through the interchange or you must exit the highway.

When you hear the siren of an emergency vehicle, you must pull over to the curb or side of the road and stop.

If oncoming drivers do not dim their headlights for you, keep your eyes on the right side of the road ahead. Do not look directly at the oncoming headlights because the glare may blind you for several seconds.

Smoking while driving can create dangerous distractions by causing you to take your hands off the wheel and/or your eyes off the road.

This is a "Keep right" sign. It indicates that a traffic island, median, or barrier is ahead and that drivers must keep to the right of it.

Warning signs are usually diamond-shaped with black markings on a yellow background. They alert drivers to upcoming hazards. This sign indicates that the divided highway is about to end.

One situation where it is appropriate to use your horn is if you lose control of your vehicle. In this case, sound your horn to alert other drivers.

Every time you have to stop quickly, it takes time and fuel to accelerate and get your vehicle back up to the speed of traffic. Drivers who look far ahead of their vehicles can slow down gradually or change lanes to avoid unnecessary braking, leading to better gas mileage.

Regulation signs regulate traffic speed and movement, displaying rules which drivers must obey. This sign tells drivers the direction in which they must drive when turning onto a one-way street.

When driving near heavy trucks, other drivers and highway users must make allowances for the increased stopping distance required by the large vehicles. Drivers of smaller vehicles should remain in locations where they can be seen by the driver of the large vehicle and where their view of traffic is not blocked by the vehicle.

If a driver's left arm and hand are extended downward, they are indicating that they intend to stop. Adjust your driving accordingly if following a driver who is using this hand signal.

Crashes often happen when some drivers go faster or slower than other vehicles on the road. Always try to drive with the flow of traffic, within the posted speed limit.

You are required to use your headlights during the day when visibility is reduced to 500 feet or less. When you first turn on your headlights, be sure they are adjusted to the low beam setting. Using high beams in fog or rain will cause the light to reflect back into your eyes, lowering visibility even more.

Because hydroplaning is caused by driving too quickly in wet conditions, the risk of it happening can be reduced by driving more slowly.

Because large vehicles have large blind spots on both sides, you should avoid driving beside a large vehicle for a long period of time. It is safest for you to either drop back or move forward when you find yourself directly next to a large vehicle.

If you must drive in foggy conditions, you should use your low beam headlights, as well as your fog lights, if your vehicle has them. High beams direct their light upwards, where it can bounce off the fog and into your eyes, reducing visibility even more.

This sign indicates that the road that you are on intersects with a divided highway. A divided highway is two one-way roadways separated by a median or guide rail.

One multilane roadways where passing is permitted, you may pass on the left side of vehicles ahead of you. You should not exceed the posted speed limit to complete a pass unless the speed limit is 55 mph or above.

When there is a solid yellow line and a broken yellow line in the center of the road and the broken line is next to your lane, you may cross the lines to pass if there is no oncoming traffic.

This sign indicates the presence of a pedestrian crossing. You should watch for people entering a crosswalk or crossing your path. Slow down and be prepared to stop.

Octagonal signs are always stop signs. Come to a complete stop when approaching a red, eight-sided sign.

In many collisions with motorcycles, bicycles, and pedestrians, drivers reported that they were looking but still did not see the smaller vehicle or pedestrian. These can be more difficult to spot in traffic than passenger vehicles because they are smaller, may move faster, and have less noticeable lighting. To prevent collisions with these smaller and less protected road users, drivers should always be alert to the presence of motorcycles, bikes, and pedestrians.

Yield the right-of-way to the driver on your right at a four-way intersection if you both arrive to the intersection at the same time. You may then proceed when it is safe to do so.

It is illegal to drive so slowly that you disrupt the normal flow of traffic. You may receive a citation for driving too slowly.

Driving faster than the posted speed limit is illegal. The posted speed limit is the maximum speed permitted on a particular road. However, the speed limit on a multilane highway with a posted speed limit of 55 mph or higher is increased by 10 mph when the driver is lawfully passing another vehicle in the same direction.