Q.1.
What can happen if the exhaust system is not working properly?
Q.2.
What is a tire load?
Q.3.
When exiting your vehicle, you:
Q.4.
If convicted of a traffic violation, you must inform your employer:
Q.5.
When a vehicle is started, warning lights and buzzers:
Q.6.
Applying the brake pedal causes air pressure to activate an electric switch and:
Q.7.
When driving with covered cargo, a cover that flaps:
Q.8.
With the exception of the straight line backing exercise, a driver may exit their vehicle and check its position during testing exercises up to:
Q.9.
After traveling under an overpass during the driving skills test, you may be asked to recall:
Q.10.
The suspension system:
Q.11.
The driver of a commercial motor vehicle:
Q.12.
To determine if a vehicle can handle a load, you should:
Q.13.
When performing a pre-trip inspection, you should make sure that:
Q.14.
If driving so slowly that you could impede other drivers, you should:
Q.15.
When transporting cargo, drivers must check the securement of the cargo every:
Q.16.
The most common type of foundation brake used is the:
Q.17.
After a tire has been changed, the driver should stop after a short distance to:
Q.18.
A driver may have:
Q.19.
How should you test the low pressure warning signal?
Q.20.
What can happen if a parking brake is used in very wet weather when temperatures are below freezing?
Q.21.
If you remain in neutral for too long while switching gears:
Q.22.
What must be done if a load is over-length?
Q.23.
What is axle weight?
Q.24.
If you don't know if there is enough space for your vehicle to pass under a bridge, you should:
Q.25.
Overloading a vehicle with cargo:
Q.26.
If your coolant level is found to be low, you should:
Q.27.
On trucks and buses, where are ABS malfunction lamps located?
Q.28.
A vehicle inspection is required:
Q.29.
After a tire has been changed, the driver should stop after a short distance to:
Q.30.
Once stopped as part of the stop/start maneuver, you should:
Q.31.
The minimum tread depth of all major grooves on tires that are not on the front of a CMV should be a minimum of:
Q.32.
Braking mechanisms are located inside:
Q.33.
One way to prevent drowsiness while driving is to:
Q.34.
Where must placards be placed?
Q.35.
When conducting a vehicle inspection, you will need to identify all of the following, except:
Q.36.
When driving, your mirrors should:
Q.37.
States verify that a CDL or CLP driver has only one such license by:
Q.38.
Which of the following is not a possible cause of a fire?
Q.39.
What is Gross Vehicle Weight (GVW)?
Q.40.
On any upgrade, gravity will:
Q.41.
Which of the following is not a part of an air brake system?
Q.42.
One way to prevent hydroplaning on wet road surfaces is to:
Q.43.
When taking the on-road driving skills test, you will be evaluated on your gear usage. You should not:
Q.44.
If trying to correct a drive-wheel braking skid, the driver should:
Q.45.
If driving a school bus, your four-way flashers should:
Q.46.
Which of the following is a good rule to follow when making a turn?
Q.47.
When starting from a complete stop, a vehicle should:
Q.48.
Cargo with a high center of gravity:
Q.49.
What is the minimum number of tie-downs required to secure a 10-foot piece of cargo?
Q.50.
What happens when a vehicle hydroplanes?