Backing a school bus is strongly discouraged and should only be done if there is no safe alternative. If you must drive in reverse, be sure to follow all proper safety protocol.

If you are asked to complete an offset back/left parking maneuver, you should first pull straight forward, then back up to the left. Your vehicle must be parked completely within the boundaries of the parking space.

A school bus driver should always approach bus stops slowly and cautiously.

Students should board a school bus slowly and in a single-file line. For safety, boarding students should use the handrail.

The function of an Anti-Lock Braking System (ABS) is to prevent a vehicle's wheels from locking up when the driver brakes hard on a slippery surface.

Passengers may stumble when getting on or off of a school bus. The driver should caution passengers to watch their step when exiting.

During the on-road driving test, you must not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

Students should not occupy the back row of a school bus unless the bus is full. The closer to the front of a bus that students are seated, the safer they will be in the event of a rear-end collision. Students with special needs should sit near the driver.

The examiner will score the number of times your vehicle touches or crosses an exercise boundary line. Each encroachment will count as an error, resulting in points against your skills test score.

When picking up passengers, a school bus driver should park with the vehicle's front bumper at least 10 feet away from the students. This is the safest parking option because it forces the students to walk to the bus, making it possible for the driver to watch their movements.

Crossover mirrors are used to help a driver see the danger zone area directly in front of a school bus. The mirrors should also display the danger zone areas to the left and right sides of the bus, including the area from the front of the bus to the service door.

Anti-Lock Braking Systems (ABS) help prevent brake lockup when driving on slippery surfaces. If a driver brakes too hard on a slippery surface, ABS makes it easier for the driver to maintain control of their vehicle. A vehicle equipped with ABS should be driven and braked in the same way as a vehicle without ABS.

If a school bus becomes stalled or trapped on railroad tracks, the driver should immediately evacuate everyone from the bus. If the bus is struck by a train, to avoid any flying debris, the students should be led far away from the bus at an angle that is in the direction of any oncoming train.

Railroad crossings that do not have any kind of traffic control device are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

If time permits, before deciding to evacuate a school bus, the driver should contact their dispatcher to explain the situation. The decision to evacuate must be a timely one.

School bus drivers should approach stops slowly and cautiously.

If a school bus is on fire, or if there is a threat of fire, it is mandatory for a bus driver to evacuate the students from the bus.

When unloading students at a school, a bus driver must secure the bus by turning off the engine. If they must leave the driver's compartment, they should remove the key from the ignition. The driver must supervise the unloading process.

When checking your vehicle's pedals during a pre-trip inspection, you should ensure that there is nothing under or around the pedals that will obstruct their use. Make sure the pedals are in proper working condition and that the surfaces of the pedals are grooved, if applicable.