If a school bus needs to be evacuated in the event of an emergency, the driver must quickly determine which exit or exits will be safest for students to use and direct the students to that exit.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading.

Crossover mirrors are used to help a driver see the danger zone area directly in front of a school bus. The mirrors should also display the danger zone areas to the left and right sides of the bus, including the area from the front of the bus to the service door.

If you are asked to alley dock, you should first pull past the alley and stop your vehicle in a position that is parallel to the outer boundary. From there, you should back your vehicle entirely into the alley parking area. Your vehicle should be parked in a straight position within the boundaries of the parking space.

During the on-road driving skills test, you may be asked to enter an expressway. Before doing so, you must check traffic, use proper signals, and merge smoothly into the proper lane.

When examining the air and electrical lines as part of your vehicle inspection test, you must listen for leaks. Ensure that the air hoses and electrical lines are not cut, chafed, spliced, or worn. Make sure air and electrical lines are not tangled, pinched, or dragging against tractor parts.

There are blind spots immediately below and in front of each outside flat mirror. These mirrors have another blind spot directly behind the rear bumper.

Railroad crossings that do not have any kind of traffic control device are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic control skills test.

You may be asked to complete a conventional parallel parking maneuver into a parking space that is to the right of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

A pre-trip inspection should be completed in the same way before every drive. Consistency will help you learn all of the proper steps and decrease the likelihood that you will forget to check something.

When stopping to pick up students, a school bus should be put in park. If the transmission does not have a park shift point, the vehicle should instead be placed in neutral.

Backing a school bus is strongly discouraged and should only be done if there is no safe alternative. If you must drive in reverse, be sure to follow all proper safety protocol.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

You should finish each exercise with your vehicle in the exact position described by the examiner. You can be penalized for failing to complete an exercise exactly in the manner described by the examiner, potentially resulting in failure of the basic control skills test.

The purpose of an Anti-Lock Braking System (ABS) is to help prevent wheel lockup and help a driver maintain control of their vehicle when braking on a slippery surface.

During the on-road driving skills test, make sure you do not put your vehicle over curbs, sidewalks, or lane markings. Stop behind stop lines, crosswalks, or stop signs. On multiple-lane roads, complete turns in the proper lane. Always move to or remain in the rightmost lane, unless the lane is blocked.

A driver is allowed to exit their vehicle to check its position during any basic vehicle control skills test exercise. This action is called a "look." During the straight line backing exercise, a driver may not exceed one look. During any other exercise, a driver may not exceed two looks.

If you drive under an overpass during the on-road driving skills test, your examiner may ask you to recall the posted clearance or height of the overpass.

If you drive over a bridge during the on-road driving skills test, the examiner may ask you afterwards to recall the bridge's posted weight limit.