In general, vehicles at a four-way stop should proceed in the order that they arrive. However, if two vehicles arrive to the intersection at the same time, the vehicle on the left must yield the right-of-way to the vehicle on the right.

This triangular sign is a "Yield" sign. When you see this sign, you must slow down to check for traffic and yield the right-of-way to pedestrians and approaching cross traffic. Stop only if it is necessary to do so.

This sign indicates that the road ahead changes direction at an extreme angle (in this case, to the right). Before you reach such an extreme curve, you should slow down as much as you would when making a turn at an intersection.

Wearing your seat belt is the single most effective thing you can do to reduce your risk of death or injury while driving.

Before passing, you should signal early enough for other drivers to know your plans in advance.

When driving on wet roads, drivers should increase their following distance.

Do not stop at an accident scene unless you are involved or emergency help has not yet arrived. Keep your attention on your driving and keep moving, watching for people who might be on or near the road. Never drive to the scene of an accident, fire, or other disaster just to look.

Chevron signs like this indicate that the road curves sharply in the direction indicated by the chevron (in this case, to the left). There may be several chevron signs placed throughout a curve.

If you miss your turn or exit, do not back up or try to turn around on the highway. Go to the next exit and safely turn around.

This sign warns that a traffic signal is ahead.

When roads are wet, cars take a longer distance to stop and may skid on quick turns. Do not use cruise control when driving under wet or icy conditions. Reduce your speed and drive with caution.

You must stop at a railroad crossing when directed to do so by a flagger or stop sign. Stop when flashing red signals and gates are present and operating.

A truck or bus has blind spots on each side, in the rear, and in the front. An automobile cannot be seen in these blind spots. These blind spots are referred to as the “No zone.”

If your vehicle breaks down on the highway, you should signal before carefully exiting the roadway and turning on your hazard flashers. Get as far off the road as possible and park in a location where other drivers can easily see you. Lift your hood to let other drivers know your vehicle is disabled.

A flashing yellow light means that you should proceed through the intersection slowly and with caution. Scan your eyes across traffic in both directions.

There are many areas where a driver cannot park. You may not park on a bridge, on an overpass, in an underpass, or in a tunnel.

Most warning signs are diamond-shaped and yellow with black markings. These signs warn drivers about unexpected conditions that may not be readily apparent.

Warning signs prepare drivers for upcoming road conditions and hazards and are usually yellow with black markings. This sign warns drivers about an upcoming steep hill. They should adjust their speed accordingly to avoid brake damage or collision.

Maximum speed limits indicate the fastest speed a driver may legally drive under ideal conditions. When driving on a paved divided highway, the maximum speed limit is 70 miles per hour. If a different speed limit is posted, follow the posted limit.

If a vehicle approaching you is using its high beams and fails to dim them, you should glance toward the right side of the road. This will keep you from being blinded by the other vehicle’s headlights and will allow you to see well enough to stay on your course until the vehicle passes.

If you drive past these signs, you are going the wrong way and are at risk of a head-on collision. You should cautiously turn around.

There are many areas where a driver cannot park. You may not park within 10 feet of a fire hydrant.

Because a large vehicle, such as a truck or bus, has large blind spots to its sides and rear, avoid driving alongside such a vehicle and do not tailgate one.

Regulatory signs are white, rectangular signs with black markings. Drivers must obey the instructions posted on all regulatory signs. Where this sign is posted, it is prohibited for drivers to pass one another.

This signs warns that a four-way intersection is ahead.