Railroad crossing warning signs are used to warn drivers of the possibility of a train. Drivers should obey all railroad crossing warning signs and never go around barriers or disregard the warning sign.

A steady green light means you may drive through the intersection if the road is clear. You may also turn right or left on a steady green light unless a sign prohibits the turn. When turning, you must yield to other vehicles and pedestrians within the intersection.

If an aggressive driver cuts you off on the roadway, stay calm and get out of their way. Trying to get even with an aggressive driver risks escalating the situation and increasing the danger.

To check your blind spot, glance over your shoulder in the direction that you want to move.

This sign indicates that the road ahead winds with a series of turns or curves.

"Reduced speed" signs inform drivers that they must reduce their speeds. If a new speed limit is posted on one of these signs, the new speed limit begins at the sign.

When approaching an intersection with a steady green traffic light, yield to pedestrians in the crosswalk and vehicles still in the intersection. You may continue driving, but should approach the intersection at a speed that will allow you to slow down and stop if the light changes before you get there.

Highway work zones are established according to the type of work underway along the roadway. Signs in work areas are typically diamond-shaped, orange, have black letters or symbols, and serve as a warning that people are working on or near the highway.

You must yield the right-of-way to police cars, fire engines, ambulances, or any other emergency vehicles using a siren or air horn and a red or blue flashing light. Follow any instructions given over the emergency vehicles' loudspeakers. Emergency vehicles often follow each other so you should proceed only when you are certain the way is clear.

Every time you have to stop quickly, it takes time and fuel to accelerate and get your vehicle back up to the speed of traffic. Drivers who look far ahead of their vehicles can slow down gradually or change lanes to avoid unnecessary braking, leading to better gas mileage.

You should pass a bicyclist the same way you would pass any other vehicle, but not so fast or close to them that you throw debris in their face or blow them around with the draft of air from your vehicle. Allow at least 3 feet of space between your side mirror and the bicyclist, or at least 5 feet on higher speed roads or when there is a group of bicyclists. Honking unnecessarily may startle riders and make them more likely to crash.

"No zones" are the large blind spots around trucks and other large vehicles. Drivers of smaller vehicles should avoid lingering in "No zones."

As you prepare to make a right turn, you should get as far to the right side of the road as possible. Do not cut across lanes of traffic to perform any turn.

When entering a roadway from a driveway or private road, you must yield the right-of-way to pedestrians and traffic on the roadway.

Anything that causes you to take your attention away from driving, take your eyes off the road, and/or take your hands off the wheel is a distraction.

You must not drive at a speed that is faster than is reasonable and prudent. You must drive at a speed that is appropriate for the area where you are driving, the type and condition of surrounding traffic, the presence of pedestrians, the weather, the quality of the road, and light conditions. You must drive within legal speed limits.

Before changing lanes, check your side and rearview mirrors for traffic approaching you from behind. Just before you begin moving into the other lane, quickly glance over your shoulder and check for any vehicles that may be in your blind spot.

Warning signs are usually diamond-shaped and yellow with black lettering or symbols. They warn drivers about special situations or potential hazards ahead.

To maintain a safe following distance, allow a gap of two to four seconds between you and the vehicle in front of you when driving at speeds of 30 mph or below. Maintain a following distance of at least four seconds when driving under normal conditions at faster speeds.

This sign indicates that there is a Y intersection ahead. You must bear either to the right or to the left.

Flashing amber lights on a school bus warn that the bus is about to stop to load or unload children. If you see these lights, prepare to stop for the bus. When its red lights flash, come to a stop before reaching the bus and remain stopped until the red lights stop flashing.

If your vehicle’s right wheels leave the pavement, don't panic. Take your foot off the accelerator and steer parallel to the road. Slow down and ease back onto the roadway by keeping both hands on the steering wheel and steering into the road’s right lane with a small turn of the steering wheel. Check for traffic around you before steering back onto the pavement.

A flashing red traffic light means the same thing as a stop sign. You must come to a complete stop, yield to cross traffic and pedestrians, and then proceed when the way is clear.

When approaching an intersection with a solid yellow traffic light, slow to a stop before entering the intersection, if it is safe to do so. If you can't stop safely, drive carefully through the intersection.

You cannot enter an intersection if traffic is backed up on the other side and you cannot get completely through the intersection. Wait until traffic ahead clears so you do not block the intersection.

A "No standing" sign means that you may only make a temporary stop to load or discharge passengers.

Before changing lanes, check your side and rearview mirrors for traffic approaching you from behind. Use your turn signal to let other drivers know you plan to change lanes. Check for other drivers who also may be moving into the same lane.

This signs indicate that U-turns are prohibited in the location where it is posted.

You must do everything you can to prevent striking a pedestrian or another vehicle, regardless of the circumstances. It is the driver’s basic responsibility to be alert to pedestrians and to yield the right-of-way to all pedestrians, even if the pedestrian is crossing the street where they should not be.

If you look into the headlights of an oncoming vehicle, the pupil of your eye will contract. After the oncoming vehicle has passed, there will be an interval of time during which the pupil must readjust to the less intense light. During this recovery period, you are virtually driving blind.

When you see any signs indicating a nearby railroad crossing, you should slow down, look for a train, and be ready to stop. If the red warning lights are flashing or the gate is down, you must stop 15 to 50 feet before the railroad tracks. Do not try to go around the gate.

Driving at night is more dangerous than driving during the day for several reasons. It is harder to see in the dark, you may be temporarily blinded by the glare from other vehicles' lights, and there are likely to be more drivers on the road who are tired or under the influence.

A solid yellow line next to your lane means that passing is not permitted from your direction.

It is estimated that drivers make 200 decisions for every mile traveled, making it vital that drivers focus their full attention on the task of driving. Performing any additional task can create a dangerous distraction.

This sign warns of two-way traffic ahead.