The overhead inside rearview mirror in a school bus is used to monitor passenger activity inside the bus.

A school bus driver should always approach bus stops slowly and cautiously.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

It is critical to the safe operation of a school bus that mirrors be properly adjusted. Always check each mirror before operating the bus.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

During the on-road driving test, do not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

Students should not occupy the back row of a school bus unless the bus is full. The closer to the front of a bus that students are seated, the safer they will be in the event of a rear-end collision. Students with special needs should sit near the driver.

School bus drivers should approach stops slowly and cautiously.

Railroad crossings that do not have any kind of traffic control device are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

If students are evacuated due to a school bus being in the direct path of a sighted tornado, the driver should lead them to shelter in a nearby building. If no such shelter is available, the driver should escort them to a nearby ditch or culvert. They should avoid areas that may be subject to flash flooding and should be far enough away from the bus that it would not fall on them if it tipped over.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic vehicle control skills test.

The process of loading or unloading students from a school bus requires a driver's full concentration. If there is a behavioral issue on the bus, wait until the exiting students are safely off the bus and out of the way before you address the problem on the bus.

When picking up passengers, a school bus driver should park with the vehicle's front bumper at least 10 feet away from the students. This is the safest parking option because it forces the students to walk to the bus, making it possible for the driver to watch their movements.

When stopping to load or unload students, a school bus should ideally be placed in park. If there is no park shift point, the bus should be placed in neutral and the parking brake should be set.

In most emergency or crisis situations, students on a school bus will be safer and more easily controlled if they are kept on the bus than if they are evacuated. However, if staying on a bus will expose the students to risk or injury, the bus driver should escort them to a safe location.

When checking your vehicle's pedals during a pre-trip inspection, you should ensure that there is nothing under or around the pedals that will obstruct their use. Make sure the pedals are in proper working condition and that the surfaces of the pedals are grooved, if applicable.

During the on-road driving test, the examiner will be scoring you on specific driving maneuvers, as well as your general driving behavior.

Railroad crossings that do not display any traffic control devices are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

When unloading students at a school, a bus driver must secure the bus by turning off the engine. If they must leave the driver's compartment, they should remove the key from the ignition. The driver must supervise the unloading process.