If your motorcycle fits you properly, your feet should be able to reach the ground while you are seated. When riding your motorcycle, keep your feet firmly on the footrests.

When preparing to pass another vehicle on its left, ride in the left portion of your lane to increase your line of sight and to make yourself more visible to any drivers in the passing lane. Use your mirrors and turn your head to check for traffic before changing lanes.

Wet pavement; roads covered in loose gravel or sand; muddy, snowy, or icy areas; painted lane markings; and metal covers and plates in the road can be slippery surfaces. Motorcyclists should ride with extra caution when riding over slippery surfaces.

When parking a motorcycle next to a curb, you should create at a 90-degree angle with the curb by touching your rear wheel to the curb.

To maintain directional control through a turn, you should look through the turn by turning only your head. Slow down before turning and lean your motorcycle in the appropriate direction.

Instead of or in addition to mechanical turn signals, operators may use hand signals to indicate turns or stops. If an operator's left arm is bent at the elbow and pointing downward, it means the operator plans to slow down or stop.

A properly chosen lane position should provide a number of benefits, including an increased ability to see others and to be seen. It should help you avoid wind blasts, other drivers' blind spots, and surface hazards. Your lane position should discourage other drivers from trying to share your lane and provide you with an escape route, should a hazard arise. Choose a lane position that maximizes your space cushion.

The minimum number of drinks left in a person's system can be estimated by subtracting the number of hours since the last drink from the total number of drinks consumed. In this case, the alcohol content of about four drinks would remain.

A properly chosen lane position should provide a number of benefits, including an increased ability to see others and to be seen. It should help you avoid wind blasts, other drivers' blind spots, and surface hazards. Your lane position should discourage other drivers from trying to share your lane and provide you with an escape route, should a hazard arise.

Give plenty of room to vehicles merging onto a highway from an entrance ramp. Merge into a lane farther away from the entrance ramp, if necessary. If it is not possible to change lanes, adjust your speed to allow room for the vehicle to safely enter the highway.

In Rhode Island, a person of any age with a blood alcohol concentration (BAC) of 0.08 percent or higher is considered legally intoxicated. It is both illegal and dangerous to operate a motor vehicle while under the influence of alcohol.

Secured loads should be low. Putting them too high up, such as on a sissy bar, can raise the motorcycle's center of gravity and upset its balance. Loads should be as evenly distributed as possible on each side of the motorcycle to avoid pulling the bike to one side.

Always simultaneously use both brakes to stop. The brakes are most effective when used at the same time.

A plastic, shatter-resistant face shield can provide protection for your entire face in the event of a crash. Goggles can protect your eyes, but not the rest of your face. A face shield also provides routine protection from dirt, dust, insects, rain, and pebbles.

You should use both brakes every time you slow or stop.

To increase your visibility, you can wear clothing that is brightly-colored or that contains reflective materials. Adding auxiliary lights to your motorcycle, using your turn signals, and flashing your brake light when appropriate are also good ways to get the attention of other road users.

To reduce the risk of injury, riders should wear a helmet, eye protection, heavy shoes or boots, full-length pants, a jacket, and full-fingered gloves. Clothing should be made of durable materials to best protect the wearer.

A plastic, impact-resistant face shield provides the greatest degree of protection for a wearer's eyes and face. Eyeglasses or sunglasses are not an adequate substitute. In Vermont, you are not legally required to wear eye or face protection if your motorcycle has a windshield, though it is recommended.

To make yourself visible to others, wearing clothing that is bright orange, red, yellow, or green is best.

Always use both brakes every time that you slow or stop.

While some people worry that wearing a helmet may dangerously limit their field of vision, this is not the case. Any approved helmet will let the operator see as far to the sides as is needed for safe riding.

Riding in cold weather for long periods of time can cause severe chill, fatigue, and even hypothermia. Be sure to wear proper clothing to protect you from the elements.

When riding at night, use your high beam (unless you are following or meeting another car), take advantage of the headlights of other vehicles, and wear reflective materials to increase your visibility. You should always be flexible about your lane position, selecting whichever position will help you to see, be seen, and have an adequate space cushion.

It is possible to use both brakes while turning, but it must be done with great care. Some of the tires' usual traction is being used to make the turn while the motorcycle is leaning, so less traction is available for stopping.

Never assume that other drivers see you, even if they make eye contact with you. It is not uncommon for drivers to look directly at a motorcyclist and still fail to notice them. Always reduce your speed when approaching an intersection.