When passing a motorcycle, allow a full lane to the motorcycle. Never crowd into the same lane as the motorcycle. Returning to the original lane too soon can force a rider to swerve to the right and into traffic or off the road.

When making a left turn, you should always begin signaling about 100 feet before the turn. You should keep your front wheels aiming straight ahead until it is safe to start your turn. This ensures that you will not be pushed into oncoming traffic if another vehicle hits you from behind.

Warning signs are usually yellow with black markings. This sign indicates that there is a steep hill ahead. Slow down and be ready to shift to a lower gear to control your speed and protect your brakes from damage.

To prevent skidding on slippery surfaces, avoid especially slippery areas, such as ice patches, wet leaves, oil, or deep puddles. The safest surface for driving is a dry, solid surface.

By definition, blind spots are areas that cannot be seen using your mirrors. To check your blind spots, you should look over your shoulders.

Driving too slowly can be dangerous because it may cause drivers behind you to become frustrated and make dangerous moves to pass you. It is safest to drive with the flow of traffic, within the legal speed limit.

When driving near a blind pedestrian, using your horn may be dangerous. Yield to the pedestrian and proceed when it is safe to do so.

A driver should watch beside, ahead, and to the rear of their car. To be a good driver, you must know what is happening all around your vehicle.

Because large commercial vehicles have large blind spots on each side, you should avoid driving beside them for long periods of time.

Keep a space between your vehicle and parked vehicles. A person may step out of a parked vehicle or out from between the parked vehicles without looking. A driver may begin moving their vehicle before realizing you are there.

If you see an emergency vehicle approaching while using its flashing lights, pull over to the right edge of the road and stop. Position yourself parallel to the curb. On one-way streets, drive toward the road edge nearest you.

Use your right foot for both braking and accelerating. You should apply the brakes gently with increasing pressure so that your vehicle stops gradually and smoothly.

To avoid the need for last-minute braking or turning, look down the road at least 10 seconds ahead of your vehicle. By looking ahead and being ready to stop or change lanes if needed, you can drive more safely, save on fuel, and help keep traffic moving at a steady pace.

When you are approaching a school bus that is stopped with its stop arm extended and lights flashing, come to a complete stop. Remain stopped until the stop signal is retracted and the flashing lights are turned off.

Diamond-shaped signs are used to warn of actual or possible hazards. The color orange is used for warning signs usually found in construction or maintenance areas.

Use your low beams when driving in fog, snow, rain, or mist. Light from high beams will reflect off of precipitation, causing a glare and making it even more difficult to see. Some vehicles are equipped with fog lights that should be used in addition to low beam headlights.

Pedestrian crosswalks are often shown by white, solid lines to emphasize pedestrian crossing points. Crosswalks may have additional lines between the white, solid lines or in place of the parallel lines. However, crosswalks may also be unmarked.

Where this sign is posted, it is prohibited to make a right turn. It would be unsafe and unlawful to make a right turn at an intersection with this sign.

To avoid the need for last-minute braking or turning, consistently watch the road far ahead of your vehicle. By looking ahead and being ready to stop or change lanes if needed, you can drive more safely, save fuel, and help keep traffic moving at a steady pace.

This sign indicates that you are approaching a railroad crossing. You must look, listen, slow down, and prepare to stop. Wait for any trains to pass before you proceed.

Large vehicles require longer distances to stop and accelerate than smaller vehicles do. Making a sudden stop in front of a large vehicle is dangerous because the other driver may not be able to stop in time to avoid a collision.

Your vehicle's blind spots are the areas that you cannot see in your mirrors. Look over the appropriate shoulder to check your blind spot when changing lanes.

This sign warns of the possible presence of merging traffic.

Warning signs are usually yellow with black markings. This sign indicates that the road ahead will turn sharply to the right and then sharply to the left.

A flashing red light at an intersection means drivers are required to come to a complete stop, yield to traffic and pedestrians, and proceed when the way is clear. The same is true at a stop sign.