A person who is age 21 or older with a blood alcohol concentration (BAC) of 0.08 percent or higher is considered legally intoxicated. It is illegal and dangerous to operate any motor vehicle while intoxicated.

A passenger should lean with the operator through turns and curves. They should sit as far forward as possible, without hindering the operator's control of the motorcycle, and hold onto passenger handholds or the operator's waist, hips, or belt.

Your horn can be a useful tool if you need to get someone's attention quickly. However, because a motorcycle's horn is not as loud as a car's, other drivers may not notice that you are sounding your horn. You should never rely only on your horn to deal with a hazard.

To reduce the risk of being involved in a crash, ensure that you are visible to others on the road. Communicate your intentions through your turn signals, brake light, and lane position. Maintain an adequate space cushion, scan your path of travel 12 seconds ahead of your vehicle, and be prepared to act if any hazards arise.

Trying to accelerate out of a wobble is dangerous and will only make your motorcycle more unstable. Instead, grip the handlebars firmly (without trying to fight the wobble), gradually close the throttle to slow down, and move your weight as far forward and downward as possible. Pull off the road as soon as you can.

When riding in a group, it is generally best to use a staggered formation. Use your mirrors periodically to check on riders behind you. Both the lead and sweep riders should be experienced motorcyclists who know group riding procedures well. Maintain proper space cushions within the group of riders.

Trying to accelerate out of a wobble will only increase the problem. Instead, grip the handlebars firmly, slow down while gradually closing the throttle, move your weight as far forward and downward as you can, and pull off the road as soon as you can. Once off the road, you should address the problem causing the wobble.

When doing a pre-ride inspection of your motorcycle, you should check the air pressure, general wear, and tread of your tires.

There is no single lane position that is always best and no single lane position that should always be avoided. Vary your lane position based on changing road and traffic conditions.

All passing maneuvers must be completed within the posted speed limits and only in areas where passing is safe and legal.

Before each ride, you should check the air pressure, tread, and general wear of your tires.

To safely cross railroad tracks, trolley tracks, or pavement seams running parallel to your lane, move to a lane position that will allow you to cross them at an angle of at least 45 degrees. Then, make a quick, sharp turn. If you try to edge across, the tracks or seam could catch your tires and throw you off balance.

Reflective material on a vest or on the sides of your helmet can make you more visible to other drivers and should be used both day and night.

Heavier items should be loaded in front of the tank bag. You should try to place the load over or in front of the rear axle. Putting the load behind the rear axle may affect your control.

If you are following a car, the driver is most likely to notice you if you position yourself behind them in the center of your lane. This lane position places you in the driver's rearview mirror. Most drivers check their rearview mirrors much more frequently than they check their side mirrors.

To provide adequate protection when riding, jackets and pants should cover your arms and legs completely. Your clothing should fit snugly but be loose enough to let you move freely. Leather or newer kinds of synthetic materials provide the best protection in the case of an accident.

When riding directly behind a car, it is usually safest to ride in the center portion of your lane. If you are riding in the center of the lane, you are most likely to be visible in the rearview mirror of the vehicle ahead. Most drivers check their rearview mirror more frequently than they check their side mirrors.

A motorcycle carrying a passenger will sit differently than usual due to the additional weight. You may need to adjust the tire pressure, suspension, shocks, headlight, and mirrors to compensate for the shift.

Before riding, you should check the pressure and condition of your tires; check the oil and fluid levels; and make sure that the low beam headlight, high beam headlight, taillight, signal lights, and brake light all work properly.

To safely ride on a slippery surface, you should reduce your speed, avoid making sudden movements, and use both brakes if you need to brake.