If two vehicles arrive at the same time to an uncontrolled intersection, the driver on the left must yield to the driver on the right. The driver on the left may then proceed when it is safe to do so.

A railroad crossing crossbuck sign is considered a yield sign and a driver must yield the right-of-way to any oncoming trains and railroad equipment.

Driving more slowly than the flow of traffic can be hazardous. If you are on a two-lane, two-way road and driving so slowly that traffic is backing up behind you, you are required to pull off the road and let the other vehicles pass. Only drive significantly under the speed limit when conditions require it.

Drinking coffee will not reduce your blood alcohol concentration (BAC). While it may help you to stay awake, it cannot change your BAC or make you sober.

Yellow lines are used to separate traffic moving in opposite directions. Dashed lines indicate that drivers directly next to the line are permitted to pass when it is safe to do so.

Pedestrians should walk on the side of the road facing the traffic in the lane nearest them.

You should never pass if there is an oncoming vehicle in the passing lane, if your view is blocked by a curve or hill, at an intersection, before or on a railroad crossing or bridge, or in any other no passing zone. Unless you are on the opposite side of a multilane roadway with a median or shared center turn lane, you may not pass a stopped school bus that has its flashing red lights activated.

Warning signs prepare drivers for upcoming road conditions and hazards and are usually yellow with black markings. This sign alerts drivers to an upcoming curve in the road.

If a steady yellow light appears when you are already within an intersection, you should continue through the intersection carefully.

A red traffic light means that you must stop before entering the intersection. You must at any stop line and before entering any crosswalk.

Distractions cause drivers to react more slowly to traffic and hazards on the roadway. Distracted driving is never safe.

Before you drive, always fasten your seat belt and make sure all your passengers are using seat belts or child restraints. Studies have shown that if you use seat belts, your chances of being hurt or killed in a traffic crash are greatly reduced. Children age 12 and under should always ride properly restrained in a rear seat. Never put a rear-facing infant restraint in the front seat of a vehicle with a front passenger airbag.

This sign warns of two-way traffic ahead.

Guide signs, sometimes known as destination signs, have a green background and provide directional and mileage information to specific destinations. They can be a helpful resource when driving in unfamiliar locations.

On slippery roads, you should increase your following distance. It may take more time to stop your vehicle than it would under normal conditions.

You must pull over to the right edge of the road and stop for an emergency vehicle with flashing lights, regardless of whether it is approaching you from behind or from the opposite direction.

When a school bus is stopped with its red lights flashing and stop arm out, other drivers are required to stop. This law applies to drivers traveling on both public and private roads.

Any defect that may affect the safe operation of a vehicle should be corrected as soon as possible. Defects should be corrected before the vehicle is driven.

This sign indicates that a divided highway begins ahead. The road will split into two one-way roadways separated by a median or divider. You must keep to the right.

Being fatigued while driving is similar in danger to driving under the influence of alcohol. If you begin to feel tired while driving, the best thing to do is to stop driving.

There are a number of locations where it is unlawful to park, including on a crosswalk or in a marked bicycle lane. When parking on the street, you must be within 12 inches of the side of the road.

When you see an emergency vehicle using its lights or hear it using its siren, you must immediately pull over to the curb or side of the road and stop.

If there is no stop line or crosswalk, you should stop at the point nearest to the intersecting roadway where you can get a view of approaching traffic. You should not enter the intersecting roadway to gain a better view.

Always be prepared to yield to any oncoming trains before crossing railroad tracks, particularly if there are no lights or gates controlling the crossing. Never start to cross the tracks until there is room for your entire vehicle on the other side of the tracks. Due to the risk of a vehicle stalling, it is not wise to shift gears when crossing railroad tracks.

This sign indicates that there is a flagger ahead controlling traffic in a construction area.