Q.1.
It refers to the technical person who has the knowledge and skills about the technology.
Q.2.
Vibration or extra noise from the operation means problems with parts and accessories are starting to develop.
Q.3.
When there is something wrong with the performance of either hand tools or equipment, they need immediate repair or maintenance.
Q.4.
This refers to the visual observation of an expert on the appearance of the tools and equipment.
Q.5.
It is lighter than a comparable electric drill.
Q.6.
The uses of the sockets and attachment from a standard socket set.
Q.7.
This is used for cleaning the floor and car interiors after service.
Q.8.
This can be either bench-mounted or installed on a pedestal
Q.9.
These are used to drive or turn screws
Q.10.
These are used to remove gears and hubs from shafts, bushings from blind holes, and cylinder liners from engine blocks.
Q.11.
These are used to turn screws, nuts, and bolts with hexagonal or six-sided heads. A variety of wrenches are used in the shop.
Q.12.
These are designed around three basic devices: the air cylinder, the vane motor, and the sprayer.
Q.13.
These are tools manipulated by our hands and with the use of electrical energy such as electric drill, grinding wheels, vacuum cleaner, and others.
Q.14.
These are tools manipulated by hands without using electrical energy such as puller, hacksaw, pull-push rule, pliers, hammer and others.
Q.15.
Under which of the following conditions is generated staticelectricity decreased?
Q.16.
The generation of static electricity on an object by rubbing is known as the
Q.17.
Which of the following types of meters are contained in themultimeter?
Q.18.
Which of the following conditions is the most probable cause for a grounded circuit?
Q.19.
An ammeter is connected into a circuit in which of the following ways?
Q.20.
Which of the following meters should you use when troubleshooting an open circuit?