If the speed of rotation of a separately excited dc machine is halved and the filed strength is also reduced to half of the original. Then the emf induced in the armature _____________
a) reduces to 1/4th of original
b) reduces to half of original
c) remains same
d) doubles
Q.2.
If the speed of rotation for a four pole,dc machine is 1 m/s, flux density ashaving length of bore as 0.and radius of 0.5m. The emf induced under pole faces will be ________
a) 0.2 V
b) 0.1 V
c) 0.2*pi V
d) 220 V
Q.3.
The induced emf in the armature of a 4-pole dc machine is ________
a) directly proportional to speed and field strength applied to it
b) directly proportional to speed
c) directly proportional to field strength applied to it
d) inversely proportional to speed and inversely proportional to field strength applied to it
Q.4.
If the armature current is by mistake increased tofor the dc machine then ________
a) the induced emf remains unchanged
b) the induced emf doubles
c) the induced emf halves
d) none of the mentioned
Q.5.
For a four pole,slot armature with two coil-side/slot having lap connected progressive winding has single turn coils. The same machine is then wave wound, the emf induced in the lap wound dc machine to that of wave wound will be ________
a) 2
b) 0.5
c) 1
d) 4
Q.6.
A duplex lap wound armature is used in six pole dc machine with six brush set. The number of current paths in this machine is?
a) 12
b) 6
c) 3
d) 2
Q.7.
For a four pole,slot armature with two coil-side/slot having wave connected progressive winding has single turn coils has simplex winding. The number of current paths is?
a) 2
b) 6
c) 3
d) 4
Q.8.
For a four pole,V dc shunt generator having armature resistance of 1 ohms. The current flowing in the armature isA. What is the back emf generated if the terminal voltage ofV supply is fed?
a) 230 Volts
b) 210 Volts
c) 190 Volts
d) 200 Volts
Q.9.
For a 4 poleV,A dc generator running at the rated rpm with no load will be ________
a) zero no load losses
b) 4000 W no load losses
c) negligible no load losses
d) none of the mentioned
Q.10.
Which of the following cannot reduce the terminal voltage of a dc shunt generator?
a) Commutation
b) Armature reaction
c) Armature ohmic losses
d) Any of the mentioned
Support mcqgeeks.com by disabling your adblocker.
Please disable the adBlock and continue. Thank you.