Q.1.

Above the critical frequency (fc) of a low-pass filter, the output voltage gain _______.

Q.2.

A mathematical operation that determines the rate of change of a curve is called __________.

Q.3.

In order to sustain oscillations in a feedback oscillator, the gain should be _________ so the Acl _______.

Q.4.

A Wien-bridge oscillator uses _________.

Q.5.

If the input to a comparator is a sine wave, the output is a

Q.6.

The ______________ input makes the summing amplifier circuit possible.

Q.7.

A triangular-wave oscillator can consist of an op-amp comparator, followed by a(n)

Q.8.

The center frequency of a band-pass filter is always equal to the

Q.9.

To operate properly, an oscillator requires an external ac input signal.

Q.10.

The feedback component in an op-amp integrator is a capacitor.

Q.11.

A mathematical operation for finding the area under the curve of a graph is called __________.

Q.12.

A basic series regulator has

Q.13.

The ramp voltage at the output of an op-amp integrator

Q.14.

A zero-level detector is a

Q.15.

For a Wien-bridge oscillator to produce a sustained sine-wave output, the phase shift around the positive feedback loop must be greater than 0°.

Q.16.

When the capacitance in an active high-pass filter increases, the critical frequency decreases.

Q.17.

A comparator is an example of a(n)

Q.18.

A two-pole high-pass active filter would have a roll-off rate of

Q.19.

A digital-to-analog converter is an application of the

Q.20.

The effectiveness of a filter in rejecting signals beyond cutoff frequency is a function of the filter roll-off rating.