Q.1.
Which of the following dimension is according to the ‘aligned system’ of dimensioning?
- a) 40
- b) 55
- c) 25
- d) 10
Q.2.
In dimensioning, the lines enclosing the dimension line are known as ____
- a) Leader line
- b) Dimension line
- c) Extension line
- d) Outline
Q.3.
When dimensioning the circle, the dimension line begins from the center of the circle.
- a) True
- b) False
Q.4.
While dimensioning a circle, the leader line and the dimension line are drawn at which angle with respect to each other?
- a) 45˚
- b) 30˚
- c) 0˚ or 180˚
- d) 90˚
Q.5.
While dimensioning holes, slots, etc. how would their number be specified?
- a) Number written on the dimension line
- b) Number is written of the leader line
- c) Number is written on the corner of page
- d) Number is written on the side of the hole or slot
Q.6.
What is the height if the dimension figures written on the dimension line?
- a) 7mm to 9mm
- b) 2mm to 3mm
- c) 6mm to 8mm
- d) 3mm to 5mm
Q.7.
While dimensioning, what should always be written before a point accompanied by a figure if the value of the figure is less than unity?
- a) 1
- b) 0
- c) 2
- d) 6
Q.8.
In unidirectional system, the figures are written along the dimension line.
- a) True
- b) False
Q.9.
In which system of dimensioning the figures can read from the bottom only?
- a) Aligned system
- b) Unidirectional system
- c) Nonaligned multidirectional system
- d) Parallel system