Q.1.
Which of the following solution is used to fill the dew cup for carrying out moisture analysis?
Q.2.
Which of the following is not a characteristic of infiltrant?
Q.3.
Which of the following treatment is given to a thin-walled bushing that is oversize on both inside and outside diameter?
Q.4.
Which of the following is not a benefit of impregnation?
Q.5.
Which of the following are major components of atomization set-up?
Q.6.
Which of the following are the stages of sintering, according to Sauerwald theory?
Q.7.
Which of the following is not a mechanism of by which surface transportation occur during solid-state sintering?
Q.8.
Which of the following condition is necessary for obtaining consistent and satisfactory sintered components?
Q.9.
Which of the following are the important temperature controls used in sintering furnace?
Q.10.
Which of the following treatment fives a ferrito-pearlitic structure in P/M steel forgings?
Q.11.
Which of the following kind of porosity leads to longer tool life?
Q.12.
Which of the following is not a characteristic of the bearings produced from iron?
Q.13.
Which of the following is not a type of bearing?