Q.1.
The included angle for V-belt is
Q.2.
The cross section of V- belt is .............
Q.3.
Which of the following drive has no Slip
Q.4.
Which type of belt is used with sprockets?
Q.5.
The intermediate mechanisms which is used to transmit power from one place to another place
Q.6.
V belts are suitable for
Q.7.
V belts are molded into
Q.8.
Which type of belt drives is used in compressors
Q.9.
The included angle for v belt drive ranges from
Q.10.
If the driving sheave of a belt has an outside diameter of 6 inches and the driven sheave has an outside diameter of 3 inches, the driven sheave rotates
Q.11.
Which parameters are represented by the two scales on a belt tension tester?
Q.12.
Gear drive don't require precise alignment of shaft.
Q.13.
Which of the following is not true about gear drives.
Q.14.
The teeth of the helical gears are cut parallel to the shaft axis
Q.15.
Due to slip of the belt, the velocity ratio of the belt drive
Q.16.
Spur Gears are used for connecting two..................
Q.17.
The stress Produced on the belt is..................
Q.18.
Belt drive is a flexible drive
Q.19.
Flat belts are used for
Q.20.
Which of the following is not a material used for belt