Q.1.
These are the types of belt that normally used in industry, except :
Q.2.
These are the types of belt that normally used in industry, except :
Q.3.
In stepped or cone pulley drive
Q.4.
In which type of belt drive multiple pulleys are mounted on a single shaft
Q.5.
In which type of belt drive multiple pulleys are mounted on a single shaft
Q.6.
In crossed or twist belt,
Q.7.
In crossed or twist belt,
Q.8.
The function of an idler pulley is to
Q.9.
The function of an idler pulley is to
Q.10.
In stepped or cone pulley drive
Q.11.
In open belt,
Q.12.
In open belt,
Q.13.
Velocity ratio of a belt drive is the ratio of speed of
Q.14.
Which of the following is not a material for belt drives
Q.15.
This type of drive is used to change the speed of the driven shaft while the driving shaft runs at constant speed
Q.16.
The belt drive which is used with shafts arranged parallel and rotating in same direction
Q.17.
What should be used to clean belts?
Q.18.
What is the drive misalignment called that results when the sheaves are at a different angle with the vertical plane?
Q.19.
Which tool is used to check for sheave parallel alignment?
Q.20.
What makes the pitch diameter of a sheave change?