Q.1.
When drawing a line using the relative coordinate system a line is created from ________.
Q.2.
Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for_________.
Q.3.
Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
Q.4.
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Q.5.
A projection weld is a type of:
Q.6.
A back or backing weld is a type of:
Q.7.
Students can complete an associate's degree in drafting which normally takes about __________ years to complete.
Q.8.
This is an angled surface used on cylinders to make them easier to handle:
Q.9.
This is the theoretically exact size from which limits of size are determined:
Q.10.
In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
Q.11.
The ________ is a standard element of a section view in a technical drawing.
Q.12.
These gears transmit power between shafts whose axes intersect at any angle:
Q.13.
The standard number of threads per inch for various diameters is the:
Q.14.
Architectural dimensioning is usually done in ________.
Q.15.
A partial auxiliary view is used to show only the __________ in the auxiliary view.
Q.16.
In this type of dimensioning, allowance must be made for bends:
Q.17.
The bounding box method for setting up an isometric drawing helps the drafter ________.
Q.18.
When creating your own blocks it is important to avoid drawing any portion of the block in the ________ layer.
Q.19.
There should be a visible gap between the wall and the _________ line.
Q.20.
The condition of a part when it contains the least amount of material is referred to as ________.
Q.21.
The typical parts list should include the _________.
Q.22.
One way to evenly space dimensions on a drawing is to use the __________.
Q.23.
A round is a rounded surface on the ________ corner of a part.
Q.24.
Using this as a communication and design review tool can help shorten the process and eliminate productivity barriers:
Q.25.
The title block used on working drawings should include the _________.
Q.26.
The thread note for a typical bolt will include the _________.
Q.27.
A full scale technical drawing will have a scale factor of ________.
Q.28.
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
Q.29.
Several of the tools used in traditional drafting include the following:
Q.30.
This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment: