Q.1.
It is customary for the first sheet of a working drawing set to include __________.
Q.2.
Some common blocks used by architectural drafters include __________.
Q.3.
The second line of dimensions out from the plan generally includes _________.
Q.4.
Some of the standard Auto-CAD text styles used in architectural drawings includes _________.
Q.5.
A fillet is a rounded surface on the ________ corner of a part.
Q.6.
Two-point perspective is also known as:
Q.7.
This type of projection is when projectors are parallel to each other, but are at an angle other than 90 degrees to the plane of projection:
Q.8.
These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:
Q.9.
Switches and relays should be shown in this position with no operating force or applied energy:
Q.10.
The Press-Pull tool will ________ the face of a solid model in the direction it faces.
Q.11.
These types of pipes are generally connected with bell and spigot joints or flanged joints:
Q.12.
An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
Q.13.
In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
Q.14.
When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.
Q.15.
This is formed where three or more surfaces intersect:
Q.16.
The text used on a typical detail sheet should be ________.
Q.17.
These items typically are not used in new designs, but are still common in high-power amplifiers:
Q.18.
A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed drawings.
Q.19.
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
Q.20.
This is used in applications for nonferrous construction:
Q.21.
Auto-CAD refers to isometric ellipses as ________.
Q.22.
Once the architect has finalized the house plans with the client any changes to the design requested by the client will require a ________.
Q.23.
The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
Q.24.
Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
Q.25.
On a floor plan the dashed line that appears approximately 24" outside the exterior wall represents the ________.
Q.26.
This type of surface is tipped to all principal planes of projection and does not appear true size in any standard view:
Q.27.
This type of solid is formed by sweeping a shape along a linear path:
Q.28.
In offset sections, offsets or bends in the cutting plane are all:
Q.29.
In the mechanical design process the first step is to ________.
Q.30.
This is a conical-shaped recess around a hole, often used to receive a tapered screw head: