The helix angle of a drill is more thanfor drilling aluminium.

Side relief angle of a single point tool is the angle

A dynamometer is a device used for the measurement of

In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.if the cutting speed is halved, then tool life will become

The tool life is said to be over if

The operation performed on a shaper is

If the grain size is __________ the tool life is better.

Broaching is applied for machining

Chemical milling operation is performed

Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.

Half nut is used to lock the lathe carriage to the lead screw for thread cutting.

The thrust force will increase with the increase in

The operation of reproduction of an outline of a template on a workpiece is called face milling.

The advantage of a broaching operation is that

In drilling bakellite and fibrous plastics, the point angle of a drill is

Internal or external threads of different pitches can be produced by

Which of the following statement is correct in regard to centreless grinding?

In a shaper, the metal is removed during

The broaching operation in which the work moves past the stationary tool is called

The usual value of the point angle of a drill is

The tool life __________ as the cutting speed increases.

For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is

Which of the following statement is correct about hot machining?

Continuous chips with built up edge are formed during machining of

The shear velocity is the velocity of

In centreless grinders, the regulating wheel is inclined at

In a shaper

The specific cutting energy used for establishing the machinability of the metal depends upon its

The aluminium oxide abrasive is chiefly used for grinding

For turning small taper on long workpiece, the suitable method is