MCQGeeks
CBSE
JEE
NTSE
NEET
English
UK Quiz
Quiz
Driving Test
Practice
Games
Quiz
Microcontroller
Avr Microcontroller Interview
Quiz 1
Solution
Q.1.
What actually are the DBDBports available in our computers?
a) they are connectors used to transfer data either serially or parallelly
b) they are the RS232 connectors used to connect two incompatible devices
c) they are the TTL logic connector pins used for communication
d) they are just data transfer pins used to transfer the data
Q.2.
What does RI handshaking signal refer to according to the RSlogic?
a) if this logic is high then a receive interrupt is generated
b) this pin is high during transmission
c) this pin is high during a reception in order to tell that the device is busy at this particular time
d) none of the mentioned
Q.3.
What is the major difference between a MAXand a MAXdevice?
a) one has one serial port other has two
b) one has inbuilt UART other doesn’t have that
c) one needs some additional circuitry to operate while the other doesn’t have that
d) one is used just for transmission while the other is used for both transmission as well as reception
Q.4.
Which of the following is correct about the baud rate during serial transmission?
a) it tells us about the speed at which the transmission is going to place
b) it tells us about the number of bits transferred during a second
c) none of the mentioned
d) all of the mentioned
Q.5.
With fosc=8 MHz, what will the count that has to filled in the UBRR register to account for thebaud rate?
a) 67H
b) CEH
c) 33H
d) 34H
Q.6.
The USART in AVR based microcontrollers operate at which of the following modes?
a) double speed asynchronous mode
b) master synchronous
c) slave synchronous
d) all of the mentioned
Q.7.
Which bit of the UCSRA is used for doubling the baud rate of the transmission?
a) DOR
b) PE
c) U2X
d) MPCM
Q.8.
What is the use of the PE and the FE bits of the UCSRA register?
a) they are used for keeping a check at the speed of transmission and reception
b) they are used for keeping a check at the data bits to be transferred
c) they are used to keep the transmission error free
d) they are used as extra redundant bits with no use
Q.9.
Which of the following bits are used for setting the data frame size?
a) UCSZ0
b) U2X
c) DOR
d) MPCM
Q.10.
Which of the following parameters should the transmitter and the receiver agree upon before starting a serial transmission?
a) baud rate
b) frame size
c) stop bit
d) all of the mentioned
Support mcqgeeks.com by disabling your adblocker.
×
Please disable the adBlock and continue.
Thank you.
Reload page