Q.1.
A diode rectifier with a C filter will have average output voltage _______ than that obtained by a rectifier without the C filter.
Q.2.
An inductor filter connected in series with a resistive load provides a
Q.3.
In the below given configuration, L is connected as a filter across the R load.
Questionpower-electronics-questions-answers3.jpg
Q.4.
The current ripple factor (CRF) is the ratio of
Q.5.
In case of an L filter, the ripple current increases with
Q.6.
In case of a C filter, if R (load resistance) is increased
Q.7.
When a certain type of filter is connected across the R load, of a full wave bridge diode biased rectifier the following output current waveform is obtained.
Questionpower-electronics-questions-answers7.jpg
Q.8.
C filters are suitable for ___________ load resistances and L filters are suitable for _____________ load resistances.
Q.9.
An LC filter will have ripple factor value___________ (For the same value of L & C)
Q.10.
In a single-phase full wave rectifier ___________ order harmonics are the most dominant