You have two switches that you need to connect using their uplink ports. The switches do not support auto-MDI. which type of cable should you use?

Use the exhibit to match the connector type on the corresponding letter on the right.

Which of the following standards is typically used in a rollover cable?

You want the LAN port on a router to the uplink port on a switch. The switch does not support auto-MDI. Which type of cable should you use?

You need to connect a workstation to a switch using a regular port on the switch (not an uplink port). The switch does not support auto-MDI. Which type of cable should you use?

Which of the following connectors is typically used on one end of the rollover cable?

You manage the two-location network shown in the exhibit. Workstations and servers at each location connect to a patch panel using behind-the-wall wiring. The patch panel then connects network hosts to one of three 1000BASE-T switches. Routers are implemented at each location together using a private WAN. The switch ports have auto-MDIX disabled.

You have purchased a new router that you need to configure. You need to connect a workstation to the router's console port to complete the configuration tasks. Which type of cable would you most likely use?